Abstract:Iron-enriched ferroelectrics are of particular interest as piezoactive components of piezoelectric-ferrite ME ceramics. This is due to the phase composition similarity and the reduction of expected interfacial doping effects during high-temperature calcination. This idea seems attractive, but laborious due to the significantly limited number of possible piezoelectric–ferrite combinations. Therefore, there is practically no data on such systems in the literature. ME composite ceramics based on the highly efficient Fe-containing Pb(Fe0.5Nb0.5)0.935Ti0.065O3 (PFNPT) ferroelectric has been studied. (100-х) wt.% Pb(Fe0.5Nb0.5)0.935Ti0.065O3 (PFNPT) + х wt.% Ni0.9Co0.1Cu0.1Fe1.9O4-d (NCCF) composite systems has been obtained by the solid-state method at 1050 °C, with no foreign phases. The specimens densities amounted to ∼80% of the theoretical. It has been shown that the ME conversion efficiency and other composites properties are significantly influenced by the PFNPT precursor pre-treatment method. The maximum value of the ME coefficient ΔΕ/ΔΗ = 75 mV/(cm Oe) has been observed for specimens with x = 50–60 made from PFNPT powder with the addition of Li2CO3. An increase in the ME composites sintering temperature to 1150 °C leads to the formation of Pb2Nb2O7 foreign phase with a pyrochlore structure along the grain boundaries. The ME coefficient ΔΕ/ΔΗ does not exceed 15 mV/(cm⋅Oe). There is an threefold decrease in the composites piezoelectric parameters (piezoelectric coefficients dij, gij), as well as in their magnetic properties (magnetizations MS, MR) due to piezophase degradation, which is presumably associated with a change in the cations distribution over A and B sublattices of the spinel structure.

In situ combination and phase formation of sol-gel derived PbTiO3/(Ni,Pb)- ferrite multiphase powders

Effect of Phase Formation on Magnetism of Sol-Gel Derived PbTiO3/(Ni, Pb) Ferrite Composite Powders

In situ formation of sol-gel derived PbTiO 3 /NiFe 2 O 4 biphase thin film

Preparation of 0.5pbtio_3/0.5nife_2o_4 Ceramic Composites by Sol-gel Method

In Situ Formation of Sol-Gel Derived Pbtio3/Nife2o4 Biphase Thin Film

Preparation of the Percolative Nickel-Zinc Ferrite/Barium Titanate Composite Ceramics with Liquid-Solid Hybrid Method

Microstructure and Properties of Sol–gel Derived PbTiO3/NiFe2O4 Multiferroic Composite Thin Film with the Two Nano-Crystalline Phases Dispersed Homogeneously

Formation of sol-gel in situ derived BTO/NZFO composite ceramics with considerable dielectric and magnetic properties

Ferroelectricity and Ferromagnetism in Fine-Grained Multiferroic Batio3/(Ni0.5zn0.5)Fe2o4 Composites Prepared by A Novel Hybrid Process

In Situ Formation of Composite Thin Film with (111) Oriented Ni0.5Zn0.5Fe2O4 Pillar Array Surrounded by BaTiO3 for Ferroelectric-Ferromagnetic Coupling

Mechanism of Doping-Induced Orientation of Magnetic Phase in a Sol–Gel-Derived Ni0.5Zn0.5Fe2O4/BaTiO3 Multiferroic Thin Film with High Magnetoelectric Coupling

Effect of poly sodium-p-styrenesulfonate on the phase formation and morphology of the hydrothermally synthesized bismuth ferrite powders

Ring- and Single-Crystal-like Superstructures of Fe-doped PbTiO3 Nanocrystals

Hydrothermal Synthesis and Phase-, Morphology-Evolution Mechanism of Lead Titanate Nanostructures Assisted with Tetramethylammonium Hydroxide

A new (1 - X)Pb(Lu1/2Nb1/2)O3-xPbTiO 3 binary ferroelectric crystal system with high Curie temperature

Magnetoelectric composite ceramics of nickel ferrite and lead zirconate titanate via in situ processing

Fe-enriched two-phase multiferroic composites based on lead ferroniobate - titanate and modified nickel ferrite

Preparation of Composite Materials Consisting of Ferroelectric SBT and Ferromagnetic NiCuZn Ferrite

Initial Permeability of Percolative PbTiO3/NiFe2O4 Composite Ceramics by a Sol–gel in Situ Process

Synthesis and Characterization of FePt Nanoparticles and FePt Nanoparticle/sio 2 -Matrix Composite Films