Microstructure and Properties of Sol–gel Derived PbTiO3/NiFe2O4 Multiferroic Composite Thin Film with the Two Nano-Crystalline Phases Dispersed Homogeneously

Lu Zhu,Yanling Dong,Xuhui Zhang,Yiying Yao,Wenjian Weng,Gaorong Han,Ning Ma,Piyi Du
DOI: https://doi.org/10.1016/j.jallcom.2010.05.025
IF: 6.2
2010-01-01
Journal of Alloys and Compounds
Abstract:Ferroelectric/ferrimagnetic PbTiO3/NiFe2O4 composite thin films with nano-scale PbTiO3 and NiFe2O4 phases homogeneously dispersed in each other were synthesized by sol–gel in situ method. The phase structure and morphology of the composite thin films and their dielectric, ferroelectric and ferromagnetic properties were measured respectively in detail. Results show that the ferroelectric/ferrimagnetic composite thin film with PbTiO3 and NiFe2O4 phases is successfully synthesized at heat-treatment temperature of 850°C. It is significantly isotropic due to the nanometer scale grain size of the constituent PbTiO3 and NiFe2O4 phases. A capacitance of 60–100pF with a good frequency independence over the conventional applied frequency range, ferroelectric hysteresis loops with the applied electric field of 500kV/cm, a saturation magnetization higher than 4.8MT, and a coercive field of 5280A/m with well suitable ferrimagnetic properties are obtained from the thin film with the composition ratio PbTiO3/NiFe2O4 of 50/50 post heat-treated at 850°C. The ferroelectric/ferrimagnetic composite thin film is desirable for multifunctional device application.
What problem does this paper attempt to address?