Abstract:<p>Liquid monopropellant rocket engines are widely used in space propulsion and are developing in the direction of non-toxic and pollution-free propellants. The use of non-toxic monopropellants with a low decomposition rate makes the start-up and shutdown processes of the engines longer, and the gas inlet assumptions that were applicable to the calculation of hydrazine monopropellant engines cannot be used. Based on the steady-state calculation model of hydroxyl ammonium nitrate (HAN)-based monopropellant engine, we propose a combined model that considers decomposition of liquid monopropellant and non-equilibrium heat transfer between fluid and solid catalyst bed, and uses this model and the gas inlet hypothesis to calculate the working process of an HAN-based monopropellant rocket engine of 60 N thrust. The calculated results are compared with the test curve, and the results show that the decomposition of liquid monopropellant plays a key role in the starting and stopping processes. When the gas inlet assumption is adopted without considering the decomposition of the liquid monopropellant, the calculated start-up time is much shorter than the hot-firing test, and there is no tail-off section when shutting down. The pressure-rise and pressure-decay curve calculated by the combined model agree well with the test curve, and the maximum deviation during the steady state is less than 10%. For HAN-based monopropellant engines, the pressure rises slowly at the first start because the temperature of catalyst bed is lower, which results in a lower rate of decomposition. When restarted shortly after a shutdown, the pressure rises rapidly due to the high temperature of the catalyst bed and the high rate of decomposition. The HAN-based monopropellant can penetrate a few millimeters downstream of the injector, and there is a significant tail when the engine is shut down, which is caused by the continued decomposition of the remaining propellant after the shutdown.</p>

Modeling of N2O monopropellant thruster pre-heating

Modeling of Spray Combustion and Heat Transfer of MMH/N2O4 in a Small Rocket Engine Using Different Mechanisms

Effect of catalytic bed porosity and mass flow rate on decomposition and combustion processes of a HAN-Based monopropellant thruster

Experimental and Numerical Studies of Ammonium Dinitramide Based Liquid Propellant Combustion in Space Thruster

Numerical Investigation of an Aerospace Thruster with ADN-based Liquid Propellant

Numerical simulation of the transient process of monopropellant rocket engines

Numerical Simulation of Wall Liquid Film in Small Bipropellant Rocket Engine

Numerical Study of Flow Boiling of ADN-Based Liquid Propellant in a Capillary

A new satellite hydrogen-oxygen microthruster combustion chamber: An experimental and numerical study

Numerical modeling of heat transfer behavior for two-phase flow in a nozzle considering phase change

Design and Modeling of MEMS-based Solid Propellant Propulsion

Performance Evaluation of Ammonium Dinitramide-based Monopropellant in a 1N Thruster

Multiparameter Collaborative Optimization and Analysis of the Non-Penetrating Tunnel Thruster

Effects of Different Initial Conditions on Combustion Process of Ammonium Dinitramide-Based Energetic Propellant in Straight Nozzle

N2O propulsion research at Tsinghua: 2003

Effects of Heat Reflux on Two-Phase Flow Characteristics in a Capillary of the ADN-Based Thruster

Injector Head Transpiration Cooling Coupled with Combustion in H-2/O-2 Subscale Thrust Chamber

Experimental Study on the Catalytic Ignition Characteristics of a Dual-Mode Ionic Liquid Propellant in Model Thrusters

Effect of Nozzle Geometry on the Performance of Laser Ablative Propulsion Thruster

Effect of Upstream Valve Opening Process on Dynamic Spray Atomization of Bipropellant Thruster Injector

Numerical and experimental research on the performance of an iodine-fed Hall thruster