Abstract:Finite-element (FE) analysis was used to compare the high-temperature responses of steel columns with two different stress-strain models: the Eurocode 3 model and the model proposed by National Institute of Standards and Technology (NIST). The comparisons were made in three different phases. The first phase compared the critical buckling temperatures predicted using forty seven column data from five different laboratories. The slenderness ratios varied from 34 to 137, and the applied axial load was 20-60 % of the room-temperature capacity. The results showed that the NIST model predicted the buckling temperature as or more accurately than the Eurocode 3 model for four of the five data sets. In the second phase, thirty unique FE models were developed to analyze the W8×35 and W14×53 column specimens with the slenderness ratio about 70. The column specimens were tested under steady-heating conditions with a target temperature in the range of 300-600 °C. The models were developed by combining the material model, temperature distributions in the specimens, and numerical scheme for non-linear analyses. Overall, the models with the NIST material properties and the measured temperature variations showed the results comparable to the test data. The deviations in the results from two different numerical approaches (modified Newton Raphson vs. arc-length) were negligible. The Eurocode 3 model made conservative predictions on the behavior of the column specimens since its retained elastic moduli are smaller than those of the NIST model at elevated temperatures. In the third phase, the column curves calibrated using the NIST model was compared with those prescribed in the ANSI/AISC-360 Appendix 4. The calibrated curve significantly deviated from the current design equation with increasing temperature, especially for the slenderness ratio from 50 to 100.

Both axial and bending yielding of composite material at elevated temperature modeled by spring stiffness

Material Yielding by Both Axial and Bending Spring Stiffness at Elevated Temperature

Fire Resistance and Bending Bearing Capacity of Fire-Resistant Steel-Concrete Composite Beams

CONSTITUTIVE MODEL FOR FINITE ELEMENT ANALYSIS OF STEEL ELEMENTS WITH BUCKLING CONSIDERED AT HIGH TEMPERATURES

Study Of Flexural Response In Strain Hardening Cementitious Composites Based On Proposed Parametric Model

Finite Element Analysis of Fire Behavior of Steel Beam under Different Elevated Temperature Conditions

Load Capacity of Concrete-Filled Steel Tubular Members with Multilayer Confinement Subjected to Coupled Axial Compression-Bending and Fire

Simulation of Mechanical Properties of Special-Shaped Concrete-Filled Steel Tubular Column and Steel Beam Joints after Fire

Nonlinear Analysis of Insulated Carbon Fiber Reinforced Polymer Strengthened Reinforced Concrete Beams in Fire

Local Buckling of Extended End-Plate Connection in Fire

58126 GEOMETRIC NONLINEAR FORMULATION FOR COMPOSITE FLEXIBLE MULTIBODY SYSTEMS CONSIDERING THERMAL EFFECT(Flexible Multibody Dynamics)

Nonlinear Pre-Fire and Post-Fire Analysis of Steel Frames

The lateral impact performance of concrete-filled steel tubular (CFST) members at high temperatures

Structural Response and Behavior Analyses of Steel Joint Components at Elevated Temperatures

An elastoplastic mechanical-thermal model for temperature rise simulation of two-dimensional triaxially braided composites under quasi-static loads

Numerical simulation of steel-concrete composite beams and slabs at elevated temperatures

Analysis and simulation on fracture of structural steel at elevated temperatures based on extended finite element method

Nonlinear Bending and Thermal Postbuckling of Functionally Graded Fiber Reinforced Composite Laminated Beams with Piezoelectric Fiber Reinforced Composite Actuators

Geometric Nonlinear Formulation for Composite Flexible Multibody Systems Considering Thermal Effect

INFLUENCE OF MATERIAL MODELS ON PREDICTING THE FIRE BEHAVIOR OF STEEL COLUMNS

Uniaxial Tensile Behavior, Flexural Properties, Empirical Calculation and Microstructure of Multi-Scale Fiber Reinforced Cement-Based Material at Elevated Temperature