Abstract:The safety of signalized intersections is of great concern. To allow for an effective evaluation measure on the safety level of intersections, traffic conflict analysis methods are commonly used. However, the existing literature has mainly focused on the statistical prediction of conflicts by using surrogate measurements, among which the spatial-temporal characteristics of the potential conflicts have been less addressed. In addition, most of the relevant studies rely on precise trajectory data, and the results could be limited to engineering applications when real-time/comprehensive trajectory data are not available. To address these issues, this study proposes a SICP (signalized intersection conflict probability) model to predict a straight-left traffic flow conflict with a spatial-temporal distribution in the heat map, which could effectively evaluate the traffic safety of the existing or prebuilt signalized intersections on urban roads. Firstly, the impact of vehicle movement characteristics on traffic conflict at signalized intersections was considered by incorporating the vehicle movement trajectory. Secondly, the signal phase was categorized in several stages (each phase contains switching and nonswitching stages); then, a vehicle-vehicle conflicts probability prediction model was established by integrating both horizontal and vertical arrival probability. Finally, to validate the performance of the proposed model, the measured data were collected from the intersection of Wushan road and Yuehan road in Tianhe District, Guangzhou, China. SSAM(Surrogate Safety Assessment Model)traffic conflict simulation was used to analyze the traffic conflict in the actual data and compared to the SICP model. A case study was conducted to reveal the evolution mechanism of the conflict risk coefficient at the signalized intersection and to estimate the safety status under the various security optimization strategies. The experimental results verified the effectiveness of the SICP model, indicating that the proposed model is effective in evaluating the safety level of existing or prebuilt signalized intersections.

Traffic Signal Warrant Study Based on Traffic Conflict Analysis for Uncontrolled Intersections

Q-learning Based Traffic Signal Control Method for an Isolated Intersection

Critical Traffic Volume Warrant of Signal Installing at Equal Weight Intersections

Critical Traffic Volume of Traffic Signal Warrant at Major-Minor Intersections

Critical traffic volume of traffic signal warrant under limited priority condition

Inter-green interval calculation for signalized intersections

Determination Method of Critical Traffic Volume for Signal Setting at T-Intersections

Research on Variable Lane Signalized Control Method

Signal Timing Method of Right——turn Vehicles Based on Mixed Traffic

Influence of signal on the capacity of signalized intersection

Development of a Procedure for Using Surrogate Safety Assessment Model and VISSIM for Safety Assessment at Signalized Intersections

Optimization of Stretching-Segment Design and Signal Timing in Traffic Control

Research on signal control methods of traffic bottlenecks in city road network

General Multi-Phase Intelligent Control Method for Traffic Flow at Single Intersection

Influence of Stretching-Segment Storage Length on Urban Traffic Flow in Signalized Intersection

A Group-Based Signal Timing Optimization Model Considering Safety for Signalized Intersections with Mixed Traffic Flows

A Semi-"Smart Predict, then Optimize" Method for Traffic Signal Control.

Development of Traffic Safety Evaluation Method Based on Simulated Conflicts at Signalized Intersections

Conflict Probability Prediction and Safety Assessment of Straight-Left Traffic Flow at Signalized Intersections

A Two-level Traffic Light Control Strategy for Preventing Incident-Based Urban Traffic Congestion

Dynamic Phase Signal Control Method for Unstable Asymmetric Traffic Flow at Intersections