Abstract:This study attempts to clarify the correlation between the structural parameters of vortex finders (diameter ratio and insertion depth) and the strong turbulent flow field and performance of cyclone separators. To elucidate the effects due to the overflow pipe diameter, insertion depth, and Reynolds number on the tangential velocity index (n) and separation efficiency, 0.3D, 0.4D, 0.5D, 0.6D, and 0.7D (where D is the diameter of the cyclone separator’s cylindrical section) were selected as the vortex finder diameter and insertion depth, which were studied using three methods: computational fluid dynamics (CFD) software Fluent, experiments, and artificial neural network simulations. With Fluent, the Reynolds stress model (RSM) of turbulence was adopted to describe transport equations, and the discrete phase model (DPM) for two-phase flow was used to calculate the efficiency and separate particles at different inlet velocities. Experiments were conducted to measure the operational pressure drop and separation efficiency of the system; subsequently, the results were used to validate the CFD calculation results. Finally, a 5–5-1 three-layer artificial neural network was established based on 336 sets of data for values of n obtained from numerical simulations. In addition, a backpropagation (BP) artificial neural network model was employed to predict the correlation between the structural and operational parameters of the cyclone separator and n values. The obtained results indicate that the BP artificial neural network can accurately predict the distribution of n values within the flow field of the cyclone. Increasing the diameter of the vortex finder with the same inlet velocity can reduce the total pressure drop due to the cyclone, thereby reducing the kinetic energy loss and improving the separation efficiency of fine particles. Increasing the insertion depth of the vortex finder leads to an increase in the values of n. Considering the stability of the flow field structure and energy dissipation, an S/D value between 0.5 and 0.6 is preferred.

A MODIFIED PRESSURE-STRAIN MODEL FOR SIMULATING STRONGLY SWIRLING FLOWS IN A CYCLONE SEPARATOR

Cyclone Separator Three-Dimensional Turbulent Flow-Field Simulation Using the Reynolds Stress Model

Numerical simulation of the particle-wall collision strength and swirling effect on the performance of the axial flow cyclone separator

Numerical Simulation of Strongly Swirling Turbulent Flows in A Liquid-Liquid Hydrocyclone Using the Reynolds Stress Transport Equation Model

Numerical Simulation of Three-Dimension Flow Field in a New-Type Cyclone Separator with a Radial Inlet Structure

Improved Modelling of Interfacial Terms in the Second-Moment Closure for Particle-Laden Flows Based on Interface-Resolved Simulation Data

Numerical simulation of the complex flow field in a new recycling cyclone separator

Numerical Simulation Study on Separation Performance of Cyclone Separator Based on Fluent

NUMERICAL SIMULATION OF FLOW FIELD IN CYCLONE OF DIFFERENT HEIGHT

Numerical simulation study of particle self-rotation velocity in cyclone separator

A study on gas flow in spiral inlet cyclone separator

CFD Simulation of an Industrial Dust Cyclone Separator: A Comparison with Empirical Models: The Influence of the Inlet Velocity and the Particle Size on Performance Factors in Situation of High Concentration of Particles

Numerical simulation of the effects of the internal components on the uniformity of the flow field in a tubular separator

Numerical Modeling of Miniature Cyclone

Experimental investigation on separation characteristics of axial cyclone separator

FLOWPATTERN EFFECT ON THE SEPARATION PERFORMANCE IN CENTRIFUGAL SEPARAT OR

Numerical Simulating the Gas-solid Flow in Square Cyclone With a Curved Inlet

Numerical Simulation Of Gas-Solids Flow And Parametrical Studies In A Horizontal Square Cyclone

Numerical Simulation of the Influence of the Lengths of Exit Tubes on the Internal Flow Field of Cyclone Separators

Simulation and experimental study of effect of vortex finder structural parameters on cyclone separator performance

Sensitization of the modified SST model to the swirling and curvature for turbulent impinging jet heat transfer