Abstract:Numerical modeling of heavily-erbium-doped fluoride fiber lasers is presented. Calculations from the model were compared with all previously reported experimental demonstrations of heavily-erbium-doped fluoride fiber lasers. Commensurate with recent modeling studies, good agreement with the measurements was achieved with the use of scaled-down rate parameters for energy transfer that corresponds to weaker interactions between Er3+ ions. For wavelength-fixed (grating) systems, we show that the measured saturation of the output power results from a combination of changes to the Boltzmann distribution arising from core temperature excursions and pump excited state absorption (ESA). In free-running systems, we show that inter-Stark level transitions that terminate on progressively higher Stark levels within the I-4(13/2) manifold in part describe the non-saturating behavior of the output power at moderate pump levels. The model was used to investigate the influence of dopant concentration, pump wavelength, pump configuration, output coupling and background loss of the fiber on laser performance. In contrast to a number of previous modeling investigations, our results show that the slope efficiency steadily increases with increasing erbium concentration as a result of the reduced rates of energy recycling caused by the weakly interacting Er3+ ions. The highest slope efficiency was obtained for a pump wavelength of 983 nm due to reduced levels of ESA, however, for both free-running and wavelength-fixed arrangements of the laser, pump ESA may ultimately preclude significant power scaling.

The Numerical Analysis of A Broadly Tunable Ytterbium-Doped Fiber Ring Laser

Modeling Rare-Earth Doped Microfiber Ring Lasers

Numerical Analysis of an Ytterbium-Doped Few-Mode Fiber Laser

Narrow Line-Width Ytterbium-Doped Fiber Ring Laser Based on Saturated Absorber

Nonlinearity Optimization of Dissipative-Soliton Fiber Laser for Generation of Pulses with 350 Kw Peak Power

Numerical Analysis of Yb3+-Doped Double-Clad Fiber Laser

A Widely Tunable Single-Longitudinal-mode Ytterbium-Doped Fiber Laser Based on Fiber Lyot Filter

A broadly tunable erbium-doped fiber ring laser: experimentation and modeling

Towards tapered Yb-doped fiber-based narrow linewidth single-mode fiber laser with high signal to Raman ratio

Numerical Analysis of Temperature Distributions in Yb-Doped Double-Clad Fiber Lasers with Consideration of Radiative Heat Transfer

Numerical Modeling and Optimization of Diode Pumped Heavily-Erbium-Doped Fluoride Fiber Lasers

Numerical Simulation and Optimization of 3.5 Μm Erbium-Doped ZrF4 Fiber Laser Pumped at 655 and 1981 Nm

Novel constant-cladding tapered-core ytterbium-doped fiber for high-power fiber laser oscillator

301 W Narrow-Linewidth In-Band Pumped Er:Yb Co-Doped Fiber Amplifier at 1585 Nm and Related Modeling for Dynamics Study and Optimization

Numerical Simulation of 980 nm-LD-Pumped Yb 3 +-Er 3 +-Tm 3 +-Codoped Fiber Amplifier for 1500 nm and 1600 nmBands

Numerical Simulation Of 980 Nm-Ld-Pumped Yb3+-Er3+-Tm3+-Codoped Fiber Amplifier For 1500nm And 1600nm Bands

The theoretical calculation and output characteristic analysis of Yb doped fiber laser

A Novel L-band Multiwavelength Erbium-Doped Fiber Ring Laser

Numerical Analysis for Multi-Position-pumped Double-Clad Fiber Lasers

Numerical modeling of multi-point side-pumped mid-infrared erbium-doped fluoride fiber lasers

Numerical Analysis and Experimental Results of Output Characteristics for Strongly Pumped Yb3+-doped Double-Clad Fiber Laser