Abstract:Abrasive water jet (AWJ) is a type of cold processing technology, and there are many factors affecting its machining effect. In this paper, a coupled Finite Element Methods-Smoothed Particle Hydrodynamics (FEM-SPH) numerical model was established to investigate the key influencing factors of AWJ machining ductile materials. The abrasive particles in the model were shaped as irregular polyhedrons, and the material properties of the abrasive particles as well as the influence mechanism of the fluid–structure interaction between the abrasive particles and the water were considered. The relative error range of experimental measured results and simulation predicted results is 22.77%–36.55%. Then, the effects of content and distribution of abrasive particles, the jet working pressure P, the traverse rate of nozzle V t r a v and the impingement angle α were systematically and quantitatively evaluated through two-way verification of experiments and simulations. It was found that: (i) Effects of stand-off distance (SOD) on the kerf profile and the quality of kerf surface was essentially determined by the content and distribution of abrasive particles. As the increase of SOD, the jet divergence gradually increases, and the kerf profile gradually changes from “U-shaped” to “V-shaped”. (ii) Experiments and simulations demonstrate that the P has a linear increasing relationship with the maximum depth h of kerf profile, and the V t r a v has a linear decreasing relationship with the maximum depth h, while it has a linear increasing relationship with the jet trailing angle β , which was independent of the ductile material type. (iii) The combined effect of V t r a v and α affects geometric parameters and surface quality of the kerf profile, under the same P, the depth of the cut surface obtained by backward cutting is only 72.1% of that of the forward cutting, while the quality of the cut surface of former one is higher than the latter one.

The Development of Study on the Abrasive Rules and Anti-Abrasive Technique of Hydraulic Machines

Sediment-wear morphology prediction method of hydraulic machine based on differential-quadrature method

Erosive Wear Mechanism of Metal Materials Used in Hydraulic Machines

Optimization of anti-wear performance evaluation method of hydraulic oil based on four-ball machine

Study of the influence of pollution particles of 5 мkм and less on the anti-wear properties of the working fluids of hydraulic drives of construction and road machinery

A literature survey on abrasive wear in hydraulic machinery

Experimental Research on the Movement Rule of Solid Particles in Centrifugal Pump

Experimental and Numerical Studies on Erosion Damage in Damping Holes on the Valve Plate of an Axial Piston Pump

Contact Analysis of Abrasive Wear

Review on computational fluid dynamics based analysis of surface erosion in hydraulic machinery

Current Situation and Prospect of Erosion Wear

Numerical simulation and abrasion prediction of two-phase turbulent flows through hydraulic turbine guide vanes

Experimental and simulation study on the influence factors of abrasive water jet machining ductile materials

Interaction Between Erosive-Wear and Corrosion of Alloy Materials for Hydroturbine in Hydroelectric Station

Coupling behavior between adhesive and abrasive wear mechanism of aero-hydraulic spool valves

Nozzle Wear in Abrasive Water Jet Based on Numerical Simulation

An Improved Eulerian-Lagrangian Method Combined with Ductile Material Model for Cavitation Erosion Assessment

Research on Multiphase Flow and Nozzle Wear in a High-Pressure Abrasive Water Jet Cutting Head

Numerical Simulation and Experimental Study on Sediment Wear of Fixed Guide Vanes of Hydraulic Turbines in Muddy River Based on Discrete Phase Model

Silt abrasion prediction of hydraulic machine components by two-fluid model

Studies of Simultaneous Friction and Corrosive Processes in the Presence of Abrasive Particles