Abstract:In order to gain insight into the influence of grain size on precipitation thermodynamics, bulk materials of coarse-grained (CG), ultrafine-grained (UFG) (with or without dislocations), and nanocrystalline (NC) 7075 Al alloy have been fabricated by solid solution treatment, equal-channel angular pressing (ECAP), or high-pressure torsion (HPT) processes. The precipitation behavior and the corresponding thermal phenomenon were studied by transmission electron microscopy (TEM) and differential scanning calorimetry (DSC) heating. The results indicated that there are significant differences in precipitation thermodynamics among the four bulk materials. In the CG and UFG materials without dislocations, homogeneous nucleation is the primary precipitation mechanism. However, the nucleation of the GP zones is suppressed at lower temperatures due to a reduction in the number of residual vacancies and the supersaturation in the UFG interiors. This is attributed to the absorption of vacancies and solute atoms by a greater volume of grain boundaries. It can be observed that the greater the excess of vacancies remaining in grain interiors, the lower the temperature at which nucleation of GP zones occurs. Defect-assisted heterogeneous nucleation was identified as the predominant precipitation mechanism in the UFG materials with dislocations and the NC materials. These defects encompass dislocations, lattice distortions, and grain boundaries. The decomposition processes of solid solutions were found to be almost complete at a lower temperature. The presence of dislocations, lattice distortions, and grain boundaries enables solute atoms to diffuse at a much faster rate, significantly enhancing the precipitation rate and reducing the nucleation and formation energies of various precipitate phases.

Thermodynamic analysis of precipitation in nanoseed crystal

Homogeneous and Heterogeneous Nucleation of Potash Alum in Drop-Based Microfluidic Device

On the crystallography of precipitation

Determination of Solubility and Nucleation Kinetics of Valnemulin Hydrochloride Solvate

Early Stages of Precipitation in Γ' Phase of a Ni–Al–Ti Model Alloy: Phase-Field and First-Principles Study

Effect of nano-impurity on liquid/solid phase transition of water droplet

Continuous Production of Water‐Soluble Nanocrystals Through Anti‐Solvent Precipitation in a Fluidic Device

The research on measuring analysis and prediction of the nanoscale precipitated phase in steel

Control of crystal morphology through supersaturation ratio and mixing conditions

Thermal stability of phase-separated nanograin structure during heat treatment

Precipitation Thermodynamics in an Al–Zn–Mg Alloy with Different Grain Sizes

Thermodynamics and Characteristics of Heterogeneous Nucleation on Fractal Surfaces

Nanocrystal growth via the precipitation method

Modeling of Nano-Particle Precipitation Process in a Membrane Dispersion Micro-Structured Reactor

Modeling Cohesive Energy and Melting Temperature of Nanocrystals

Phase-field model of grain boundary diffusion in nanocrystalline solids: Anisotropic fluctuations, anomalous diffusion, and precipitation

Thermodynamics of heterogeneous crystal nucleation in contact and immersion modes

Interpretation on a Nonclassical Crystallization Route of Prussian White Nanocrystal Preparation

Size Effect on Nucleation Rate for Homogeneous Crystallization of Nanoscale Water Film

Precipitation in aqueous mixtures with addition of strongly hydrophilic or hydrophobic solute

Grain Growth Kinetics of SnO 2 Nanocrystals Synthesized by Precipitation Method