Abstract:The application of RF cavity beam position monitors (CBPM) is essential for precise beam position measurements in X-ray Free-Electron Lasers (XFEL) and linear colliders. This paper addresses the solution to the inter-bunch signal interference when the bunch separation is as short as nanoseconds. The signals can overlap from bunch to bunch, which can induce appreciable error in evaluating beam position. We propose a conceptual method to eliminate the dominant signal overlap under a quadrature phase offset condition. Using this method, the elimination automatically occurs in the process of signal digitalization. The dominant interference that is contributed by the last bunch can be reduced over an order of magnitude in a conventional CBPM system. In addition, the required bandwidth can be effectively reduced by a factor of 2, and the design challenge for a wideband CBPM is relaxed. The method was demonstrated in an analytic approach by simulating the signal evolution in the RF front end of electronics built in MATLAB code. In the practical concern of applying this method, the factors that perturb the elimination have been examined as well. Based on the numerical result, the CBPM prototype has been designed for the pre-research plan of future high repetition rate hard XFEL at Chinese Academy of Engineering Physics. The combined simulations in CST and MATLAB on the CBPM prototype indicate agreement with the result obtained in the analytic approach.

The Study of New Signal Processing Technique in Photon Beam Position Monitors

Photon Beam Position Monitor Signal Processing System with Logarithmic Ratio Method

Development of fiber beam loss monitor based on Cerenkov principle

Design and Measurement of Signal Processing System for Cavity Beam Position Monitor

A method of bunch by bunch measurement at nanoseconds interval by using cavity beam position monitors

PERFORMANCE ANALYSIS OF PHOTON BEAM POSITION MONITORS BASED ON PHOTOELECTRIC EFFECT

Photon beam position monitor based on position-sensitive detector for HLS

Subpicosecond Beam Length Measurement Study Based on the Tm010 Mode

Development of A Psd-Based Photon Beam Position Measurement System

Research of Signal-Processing Methods in Four-Quadrant Photodetector

Signal Processing System for Beam Position Monitor at HLS 200 MeV LINAC

Application and Design of Photon Beam Position Monitor in HLS

Study and Numerical Simulation of a Surface Plasmon Resonance Sensor Using Bi-Beam Differential Measurement Approach

Photon Beam Position Monitor Using Beam Profile System for HLS

Development Of A Split Photon Beam Position Monitor For Hls

Mapping of Strip Line Beam Position Monitor at HLS LINAC Based on Logarithm Ratio Processing Method

A New Wide-Band Beam Current Monitor with Active-Passive Circuit

High Resolution and High Precision Beam Profile Monitor for Particle Accelerator using linear contact image sensor

A Beam Position Measurement System of Fully Digital Signal Processing at Ssrf

Beam Size and Position Measurement Based on Logarithm Processing Algorithm in HLS II

V-coupling-blade Beam Position Monitor: Test and Performance