Abstract:For the measurement of text high-speed communication signals, whether it is to check the signal's bit error rate (BER) with a BER tester or to record the signal's eye diagram with an equivalent-time oscilloscope, a clock and data recovery (CDR) circuit is required to generate a trigger signal properly aligned to the input data signal. For the system under test, where multiple communication protocols coexist, a wide operation frequency range and low-jitter CDR circuit can undoubtedly improve the measurement efficiency and reduce the cost. However, obtaining broad frequency coverage and minimal recovery clock jitter simultaneously has always been a challenge in the design of CDR circuits. This article proposes a CDR circuit combining a multiband LC-voltage-controlled oscillator (VCO) and a configurable frequency divider, which effectively expands the operating frequency range of the CDR while maintaining the low jitter of the recovered clock. A 0.2–7.1-Gb/s CDR circuits with a 1.9-ps rms jitter of the recovered clock under a 7.1-Gb/s input pseudorandom binary sequence (PRBS) signal is implemented in 65-nm CMOS. Compared with other LC-VCO-based CDRs, the proposed CDR achieves better energy efficiency and lower jitter performance.

A 3.3v Low-Jitter Frequency Synthesizer Applied to Fast Ethernet Transceiver

3 V low-jitter frequency synthesizer for a fast ethernet transceiver

A Low-Jitter and Low-Power Frequency Synthesizer Applied to 1000Base-T Ethernet

A low-jitter frequency synthesizer with dynamic phase interpolation for high-speed Ethernet.

A 1.8 V Low-jitter Clock Generator for 1000 Base-T Ethernet Transceiver

A 1.2 Gbps Failsafe Low Jitter LVDS Transmitter-Receiver Applied in CMOS Image Sensor.

A 1.8v Transmitter For 10/100 Mbps Ethernet Physical Layer

Power and Area Efficient CMOS Clock Recovery Circuit for 10/100 Base-T Ethernet

A ${\hbox{70}}{\hbox{–}} {\Hbox{78-}}{\Hbox{ghz}}$ Integrated CMOS Frequency Synthesizer for $W$ -Band Satellite Communications

Design of a High-speed Frequency Multiplier Used in 2.5 Gbps Ethernet Transceiver

3.125Gb/s Transmitter with 0.18μm CMOS Process

A 10Gb/s source-synchronous transmitter in 65nm CMOS technology

A 0.18 μm CMOS 10-Gb/S multichannel transmitter with duty-cycle correction

A Low-Power Fast-Settling Bond-Wire Frequency Synthesizer with a Dynamic-Bandwidth Scheme

A 1.8 V Analog Front-End for Gigabit Ethernet Receiver

A CMOS 3.125 Gb/s Receiver for Multichannel 10 Gbit Ethernet Interface

A Low Jitter 2.125ghz Serial Link for Optical Transmission

Equalizer for 10Base-T/100base-tx Ethernet Transceiver Based on DSP Structure

A 0.2–7.1-Gb/s Low-Jitter Full-Rate Reference-Less CDR for Communication Signal Analyzers

A Power Efficient 1.0625-3.125 Gb/s Serial Transceiver in 130 Nm Digital CMOS for Multi-Standard Applications.

A Scheduling Algorithm for Low Jitter in Ethernet-Based Fronthaul