Abstract:The output waveform of the electromagnetic pulse generation circuit (EPGC) with avalanche transistors as a switch had a rising edge of hundreds of picoseconds, and its spectrum covered tens of megahertz to several gigahertz. The EPGC was integrated with a printed circuit board, the size of which was several centimeters. The size is comparable with the wavelength of the corresponding pulse spectrum, so the traditional lumped parameter circuit analysis method is no longer suitable. This paper proposed a technique of co-simulation using physical models of avalanche transistor semiconductors and circuit board microstrip line equivalent circuit models. We introduced the transistor physical model, printed circuit board equivalent model, and LRC (inductance, capacitor, and resistor) components into the TCAD software to simulate the output characteristics of the EPGC of the avalanche transistor. Based on the experimental measurement data, we have verified the proposed model's effectiveness by comparing several methods for the simulation of output pulses of the EPGC. The results showed that the proposed model was more than ten times more accurate than the traditional method for waveform amplitude simulation. In addition, the switching-on process of the first-stage avalanche transistor mainly determined the delay stability of the output pulse of the solid-state pulse source. The maximum transistor hot spot is located at the interface of n 0 -n + in the collector. The first stage avalanche transistor had a smaller temperature rise and higher thermal reliability. Therefore, we could shorten the design iteration period of the electromagnetic pulse generation circuit based on the proposed model.

Performance Analysis of the Helical Passive Electromagnetic Pulse Generator

Dynamic Analysis of a Current Source Inductively Coupled Power Transfer System

The Electromagnetic Field Analysis of Permanent Magnet Synchronous Generator Based on ANSYS

Transient Analysis of Transmission Lines Loaded by Active Devices Illuminated by an Electro-Magnetic Pulse in the Indoor Environment

Investigation on Time- and Frequency-Domain Responses of Some Complex Composite Structures in the Presence of High-Power Electromagnetic Pulses

Analysis on the performance of explosive magnetic generator of frequency based on equivalent circuit

Analysis of the Thermal Effects of Gaasfets under the High-Power Electromagnetic Pulses

Emulating Radiative Field of Electromagnetic Pulse Generator Deployed with Co-Design Capacitor under Dynamic Switching Process

Electromagnetic Performance Analysis of Rim-Driven Generator

Analysis of Electric Oscillations in Explosive Magnetic Generators of Frequency

Study on the Radiation Performance of Helix Magnetic Flux Compression Generator with Loading Capacitance

An Inductive-capacitive Hybrid Pulsed-power Supply for Electromagnetic Launch

An Energy-Saving Pulsed Magnetic Field Generator Based on Modular Marx Circuit

The Meat Grinder With CPFU: A Novel Circuit for Inductive Pulsed Power Supplies

High Performance Energy Selective Surface based on Equivalent Circuit Design Approach

Modeling the Performance of Electromagnetic Pulse Generation Circuit Based on Avalanche Transistor Switches

Equivalent circuit analysis for explosive magnetic frequency generators

Research on radiation of Magnetic Flux Compression Generator with capacitive load

Calculation and analysis of 3D electromagnetic field for high speed permanent magnet generator end region with back around winding

A Compact High Voltage Pulse Generator for Bounded-wave EMP Simulator

Measurement and analysis of radiated electromagnetic fields around the pulsed power supplies