Abstract:The performance parameters of reflecting mirrors such as absorption coefficient or thermal distortion determine the beam quality of the output laser, so the quality of mirrors is one of the most important factors affecting the capability of the whole laser system. At the present time, there was obviously insufficient in test methods for the mirrors performance. The reflection coefficient, absorption coefficient and scattering coefficient of mirrors could be measured by a lot of test methods such as cavity ring-down method, photothermal deflection method, surface thermal lens method and laser calorimetry. But these methods could not test under high power density radiation. So the test data and results could not indicate the real performance in a real laser system exactly. Testing in a real laser system would be expensive and time consuming. Therefore, the test sequence and data would not be sufficient to analyze and realize the performance of mirrors.To examine the performance of mirrors under high power density radiation, the working principle of intra-cavity was introduced in this paper. Utilizing an output mirror with a low output coupling ratio, an intra-cavity could produce high-power density laser in the resonant cavity on the basis of a relatively small scale of gain medium, and the consumption and cost were very low relatively. Based on a discharge-drived CW DF chemical laser, an intra-cavity device was established. A laser beam of 3kw/cm(2) was achieved in the resonant cavity. Two pieces of 22.5 degree mirrors and two pieces of 45 degree mirrors could be tested simultaneously. Absorption coefficient and thermal distortion were measured by calorimetry and Hartmann wavefront sensor respectively. This device was simple, convenient, low-maintenance, and could work for a long time. The test results would provide support for process improvement of mirrors.

Choice of Cavity's Parameters for a Discharge Driven Infrared Multi-Band Chemical Laser

An Intra-Cavity Device With A Discharge-Drived Cw Df Chemical Laser

Choice of Resonant Cavity for LD End-Pumped Solid-State Lasers

Preliminary Studies of a Laser Source Used to Test Mirrors under High Power Density with a Closed Cavity

Spatial Chirp And Angular Dispersion Of A Laser Crystal For A Four-Mirror Cavity Kerr-Lens Mode-Locked Laser

Chosing Cavity Axis for a Discharge Driven CW Line-Selected HF/DF Chemical Laser

Directional Emission Micro-Cavity Lasers with Different Device Structures

The Research on Improving the Characteristics of Laser Output with Diffractive Optical Elements

Influence of Resonator Mirror Surfaces on Output Mode of Radio Frequency Slab CO2Lasers

The Micro-Cavity Lasers with Different Device Sizes for the Directional Emission

Single-mode Characteristics of Short Coupled-Cavity Semiconductor Lasers

Optimizing Design of the Cat's Eye Cavity in a Nanometer Laser Ruler

The Experimental Research of a New Laser Resonator for High Power Tranverse Flow CO2 Laser

Choosing cavity parameters in cavity ring-down method

Influence of Thermal Deformation in Cavity Mirrors on Beam Propagation Characteristics of High-Power Slab Lasers

Optimization of Brightness in a Nd:YAG Laser by Maximizing the Single-Mode Power Factor with an Intra-Cavity Spatial Light Modulator

Study on Start Cavity Suitable to SBS Laser

Study on Operating Parameter of Optically Pumped Cavity NH3 Far-infrared Laser

Design of Quantum Cascade Microcavity Lasers Based on Q Factor Versus Etching Depth

On the importance of cavity-length and heat dissipation in GaN-based vertical-cavity surface-emitting lasers

Theoretic Analysis of the Cat’s Eye Cavity He-Ne Laser