Abstract:In the autoclave curing of laminates, the viscosity of the resin is very important for controlling the fabrication of composite structures. In this paper it is proposed to measure changes of viscosity of composite resin using fiber optic microbend attenuation. Optical fibers are selected and processed to increase sensitivities. Experimental viscosity measurements for different layup conditions have been made, and the results are compared with those of dielectric measurement. It is found that fiber optic attenuation is sensitive to composite cure monitoring in an autoclave with good reliability, and can indicate the point of lowest viscosity, the gel point, and the end point of the cure. The sensitivity is found to be related to the crossing angle between optical fiber and reinforcing fiber and to the pressure in the cure process. Embedded optical fibers that can be used for cure monitoring and that maintain optical waveguide performance have been developed for use in two sorts of vibration sensors (SMS-A and SMS-B) based on fiber optic vibration-mode statistics. In an experiment using an SMS-A sensor, the sensor precision is evaluated and shows that the measurement results are accurate and credible. A method of evaluating mechanical characteristics by vibration measurement is also described. In an experiment using an SMS-B sensor, measurements of vibration frequencies and amplitudes were made, and the factors that influence their sensitivity and measurement range are discussed. (C) 2001 Society of Photo-Optical Instrumentation Engineers.

Simultaneous measurement of strain and temperature during and after cure of unsymmetric composite laminate using fiber-optic sensors

In-situ monitoring of carbon fiber/epoxy composite with FBG sensors under curing and thermal cycling conditions

Real-time cure monitoring of smart composite materials using extrinsic Fabry-Perot interferometer and fiber Bragg grating sensors

CURE MONITORING OF COMPOSITES USING FIBER BRAGG GRATING SENSORS

Measurement of process-induced stresses in composite laminates by FBG sensors

Application of Fiber Bragg Grating Sensors in Monitoring Curing Process of Carbon Fiber Composite

Simultaneous Strain and Temperature Measurements in Composites Using A Multiplexed Fibre Bragg Grating Sensor and an Extrinsic Fabry-Perot Sensor

Application Of An Improved Efpi/Fbg Sensor System To Simultaneous Strain/Temperature Measurement Of Advanced 3-D Braided Composite Materials

Simultaneous Strain and Temperature Measurement of Advanced 3-D Braided Composite Materials Using an Improved EFPI/FBG System

Magnetic Fiber Enabled Curing Electrogram: Real-time Process Monitoring for Thermosetting Polymer Materials

Study of Monitoring CF3052 /5224 Composites Molding Process by Optical Fiber Bragg Grating

Simultaneous measurement of temperature and strain using double-cladding fiber based hybrid Bragg grating

Simultaneous Strain and Temperature Measurement Using an Integrated Fibre Bragg Grating Extrinsic Fabry-Perot Sensor

In-situ Cure Monitoring of Thick CFRP Using Multifunctional Piezoelectric-Fiber Hybrid Sensor Network

A Novel Multifunctional Optical Fiber Sensor Based on Fbg and Fiber Optic Coupler

Investigation Of Multifunctional Fiber Optic Sensor In Smart Composite

Fiber-optic Composite Cure Sensor: Monitoring the Curing Process of Composite Material Based on Intensity Modulation

A single three-parameter tilted fibre Bragg grating sensor to monitor the thermosetting composite curing process

Simultaneous Measurements of Strain and Temperature with Dual Fiber Bragg Gratings for Pervasive Computing

Monitoring of Cure Strain on the Interface Between Filament Wound Composites and Aluminum Plate Using FBG

Structural Health Monitoring of Smart Composite Materials by Using EFPI and FBG Sensors