Abstract:This paper presents a numerical approach to simulate sliding friction between engineering surfaces with 3D roughness in point contacts. The numerical approach is developed on the basis of the deterministic solutions of mixed lubrication, which is able to predict the locations where the asperity contacts occur, and the pressure distribution over both lubrication and contact areas. If the friction coefficients over the contacting asperities have been determined, total friction force between the surfaces can be calculated by summing up the two components, i.e., the boundary friction contributed by contacting asperities and the shear stress in hydrodynamic regions. The fi-ictions from asperity contact were determined in terms of a limiting shear stress or shearstrength of boundary, films while the fluid shear stress in the lubrication areas was calculated using different rheology models for the lubricant, in order to find which one would be more reliable in predicting fluid tractions. The simulations covered the entire lubrication, regime, including full-film Elastohydrodynamic Lubrication (EHL), mixed lubrication, and boundary lubrication. The results, when being plotted as a function of sliding velocity, give a Stribeck-type friction curve. This provides an opportunity to study friction change during the transition of lubrication conditions and to compare friction performance oil different rough surpces, which is of great value in engineering practice. Experiments were conducted on a commercial test device-universal material tester (UMT) to measure friction at a fixed load but different sliding velocities in reciprocal or rotary motions. The results also give rise to the Stribeck friction curvesfor different rough surfaces, which are to be compared with the results from simulations. The samples were prepared with typical machined surfaces in different roughness heights and textures, and in point contacts with steel ball. Results show that there is a general agreement between the experiments and simulations. It is found that surface features, such as roughness amplitude and patterns, may have a significant effect on the critical speed of transition firom hydrodynamic to mixed lubrication. It? the regime of mixed lubrication, rougher samples would give rise to a higherfiriction if the operation conditions are the same.

Calculating Friction Force by the Variation of Potential on the Contact Surfaces During Sliding

Calculating Frictional Force with Considering Material Microstructure and Potential on Contact Surfaces

Potential Model of Contact Surfaces for Calculating Static Friction Force

Study on the Energy Method of Calculating Friction Force

Application of Energy Principle to Dry Sliding Friction

Friction Force Calculation in A Quasi-Static Sliding Process Based on the Energy Principle

Calculating Atomic Scale Frictional Force with Composite Oscillator Model

A Calculating Model of Sliding Friction Coefficient Based on Non-Continuous Energy Dissipation

Calculating Model and Corresponding Analysis of Sliding Friction Coefficient Based on Thermal Dynamic Coupling

Interfacial Potential Barrier Theory of Friction and Wear

Interfacial Friction Calculation Based on the Coupled-Oscillator Model

Quantitative Calculation of Atomic-Scale Frictionalbehavior of Two-Dimensional Material Based on Slidingpotential Energy Surface

Micro Sliding Friction Model Considering Periodic Variation Stress Distribution of Contact Surface and Experimental Verification

Relationship Between the Real Contact Area and Contact Force in Pre-Sliding Regime

Simulations And Measurements Of Sliding Friction Between Rough Surfaces In Point Contacts: From Ehl To Boundary Lubrication

Frictional Behaviour of Engineering Surfaces in Overall Lubrication Regimes of Point Contacts

Modelling tangential friction considering contact pressure distribution of rough surfaces

Quantitative calculation of atomic-scale frictional behavior of two-dimensional material based on sliding potential energy surface

A Dynamic Friction Model for Unlubricated Rough Planar Surfaces

Simulation for Rubber Friction on Self-Affine Surface Based on Energy Method

Study on Discontinucous Energy Dissipation Mechanism of Friction