Abstract:Friction resistance usually constitutes one of the two main components for the calculation of required jacking force. This paper provides a new approach to predict the friction resistance of slurry pipe jacking. First, the existing prediction equations and their establishment methods and essential hypotheses used were carefully summarized and compared, providing good foundations for the establishment of the new model. It was found that the friction resistance can be uniformly calculated by multiplying an effective friction coefficient and the normal force acting on the external surface of the pipe. This effective friction coefficient is introduced to reflect the effect of contact state of pipe-soil-slurry, highly affected by the effect of lubrication and the interaction of pipe-soil-slurry. The critical quantity of pipe-soil contact angle (or width) involved may be calculated by Persson’s contact model. Then, the equation of normal force was rederived and determined, in which the vertical soil stress should be calculated by Terzaghi’s silo model with parameters proposed by the UK Pipe Jacking Association. Different from the existing prediction models, this new approach has taken into full consideration the effect of lubrication, soil properties (such as internal friction angle, cohesion, and void ratio), and design parameters (such as buried depth, overcut, and pipe diameter). In addition, four field cases and a numerical simulation case with various soils and design parameters were carefully selected to check out the capability of the new model. There was greater satisfaction with the measured data as compared to the existing models and the numerical simulation approach, indicating that the new approach not only has higher accuracy but is also more flexible and has a wider applicability. Finally, the influence of buried depth, overcut, and pipe diameter on the friction resistance and lubrication efficiency were analyzed, and the results can be helpful for the future design.

Research on Mechanism of Reducing Friction Through Injecting Slurry in Pipe Jacking

TESTING STUDY AND ANALYSIS ON SOIL DISTURBANCE INDUCED BY PIPE JACKING CONSTRUCTION

Research on Dewatering Characteristics of Waste Slurry from Pipe Jacking Construction

Environmental Effects Caused by Construction of Rectangular Jacking Pipes with Large Section, Small Space and Shallow Overburden

Formulation optimization and performance analysis of the thixotropic slurry for large-section rectangular pipe jacking in anhydrous sand

Calculation of Friction Force for Slurry Pipe Jacking considering Soil-Slurry-Pipe Interaction

In-situ Test Research on Influence of Pipe Jacking on Soil

Factors Analysis of Parallel Underground Pipelines Displacements Affected by Pipe Jacking

3D FEM ANALYSIS ON DEFORMATION OF PERPENDICULARLY CROSSING BURIED PIPELINE IN PIPE JACKING

Design and Analysis of Grouting Pressure in Slurry Pipe Jacking Based on the Surrounding Soil Stability Mechanical Characteristics

Effect of Lubrication Strength on Efficiency of Slurry Pipe Jacking

Site-based Experimental Study on Pipe Behavior During Pipe Jacking

Physical Modeling Study on Treatment of Waste Slurry with Vacuum Preloading at Bottom Combined with Upper Surcharge Loading

Prediction of Friction Resistance for Slurry Pipe Jacking

Dewatering characteristics of waste slurry from pipe jacking based on improved vacuum filtration method

Frictional resistance calculation and jacking force prediction of rectangular pipe jacking

Influence of the Advance Jacked Pipe on the Jacking Force of the Subsequent Pipe Based on Pipe–Soil Full Contact Model

Study on Soil-Compacting Effects Induced by Pipe Jacking Construction

Development and Field Application of an Automated Pipe Jacking Friction Resistance Identification and Warning System in Construction

STUDY OF COMPACTING SOIL DISPLACEMENTS AROUND JACKED SINGLE PILE BASED ON EXCESS PORE PRESSURE DISSIPATION

Analytical Analysis of Pipeline–soil Interaction During J-lay on a Plastic Seabed with Bearing Resistance Proportional to Depth