Abstract:Rockfill is a common irregular granular material used in most dam construction projects. The purpose of this paper is to investigate the distribution and size-dependent properties of the mechanical parameters describing the elastic properties and crushing strength of rockfill particles. These statistics can be used as a reference to calibrate the input parameters of numerical models when studying the macroscopic behavior of rockfill with particle breakage using the discrete element method. A series of limestone particles ranging in diameter from 20 to 240 mm were measured in this study using a single particle compression test. The elastic modulus, elastic contact stiffness, tensile stress and fracture force were then determined by characterizing each experimental force–displacement curve. Classical statistical methods were used. It has been shown that Weibull, lognormal and logistic functions can all represent the distributional features of the elastic modulus, tensile stress and fracture force, with the lognormal function being the optimal type here. As the grain size increases, the elastic modulus and tensile stress decrease, while the fracture force rises. Empirical models of power functions effectively reproduced these size-dependent laws. Meanwhile, the relationship between these parameters was also established. Finally, the lognormal function was adopted to express the randomness of the maximum elastic contact stiffness. Some suggestions were made after discussing the positive association between the maximum elastic contact stiffness and grain size. Moreover, the evaluation of the loading strain rates of individual particles tested shows that the present conclusions are applicable to quasi-static case.

Research on Strength-Deformation Characteristics and Nonlinear Elastic Model of Rockfills

A Strain Hardening Model for the Stress-Path-dependent Shear Behavior of Rockfills

A Strain Hardening Model for Rockfills

Comparison and Verification of Constitutive Models for Rockfill Materials under Complex Stress Path

Numerical Simulation of the Shear Behavior of Rockfills

Modified Rowe's Dilatancy Law of Rockfill and Shen Zhujiang's Double Yield Surfaces Elastoplastic Model

Comparison between Duncan and Chang's EB Model and the Generalized Plasticity Model in the Analysis of a High Earth-Rockfill Dam.

Development and evaluation of a practical nonlinear elastic constitutive model for rockfill dam deformation simulation based on monitoring results

Experimental investigation of statistical characteristics of elastic mechanical parameters and strength indexes of rockfill particles

An Empirical Model For The Wetting Deformation Of Rockfill

Large Deformation Finite Element Analysis on Excavated Slopes

A Rheological Model to Simulate the Shear Creep Behavior of Rockfills Considering the Influence of Stress States

Numerical Analysis of Dynamic Response of Large-Diameter Rock-Socketed Monopiles under Seismic Loads

An Elasto-Plastic Damage Model for Rocks Based on a New Nonlinear Strength Criterion

Influence of Weak Rock on Stress-Deformation of Auxiliary Dam 1 # of Xilongchi Upper Reservoir

Numerical Analysis of Dynamic Compaction Using Large Deformation Theory

Improvement of Duncan-Chang Nonlinear Model and Shen Zhujiang's Elastoplastic Model for Granular Soils

A Large Triaxial Investigation of the Stress-Path-dependent Behavior of Compacted Rockfill

Elasto-Plastic Dynamic Finite Element Analysis of an Earth-Rockfill Dam

Non-linear Elastic Model Considering Soil Structural Damage

A Density-Dependent Constitutive Model of Rockfill as Well as a Dynamic Contact Technique for Simulation of Dynamic Compaction with MPM