Abstract:Sheet metal forming technologies have been intensively studied for decades to meet the increasing demand for lightweight metal components. To surmount the springback occurring in sheet metal forming processes, numerous studies have been performed to develop compensation methods. However, for most existing methods, the development cycle is still considerably time-consumptive and demands high computational or capital cost. In this paper, a novel theory-guided regularization method for training of deep neural networks (DNNs), implanted in a learning system, is introduced to learn the intrinsic relationship between the workpiece shape after springback and the required process parameter, e.g., loading stroke, in sheet metal bending processes. By directly bridging the workpiece shape to the process parameter, issues concerning springback in the process design would be circumvented. The novel regularization method utilizes the well-recognized theories in material mechanics, Swift's law, by penalizing divergence from this law throughout the network training process. The regularization is implemented by a multi-task learning network architecture, with the learning of extra tasks regularized during training. The stress-strain curve describing the material properties and the prior knowledge used to guide learning are stored in the database and the knowledge base, respectively. One can obtain the predicted loading stroke for a new workpiece shape by importing the target geometry through the user interface. In this research, the neural models were found to outperform a traditional machine learning model, support vector regression model, in experiments with different amount of training data. Through a series of studies with varying conditions of training data structure and amount, workpiece material and applied bending processes, the theory-guided DNN has been shown to achieve superior generalization and learning consistency than the data-driven DNNs, especial-y when only scarce and scattered experiment data are available for training which is often the case in practice. The theory-guided DNN could also be applicable to other sheet metal forming processes. It provides an alternative method for compensating springback with significantly shorter development cycle and less capital cost and computational requirement than traditional compensation methods in sheet metal forming industry.

Research of the bending part blank calculation based on a back-propagation neural network

Deep Learning in Sheet Metal Bending With a Novel Theory-Guided Deep Neural Network

Dynamic Evaluation Method of Straightness Considering Time-Dependent Springback in Bending-Straightening Based on GA-BP Neural Network

Error Prediction of Springback in Bending Process Based on GA-BPNN for Accurate Forming Angle

Bending deformation prediction in a welded square thin-walled aluminum alloy tube structure using an artificial neural network

Application of Back-Propagation Neural Network for Controlling the Front End Bending Phenomenon in Plate Rolling

Prediction of bending parameters and automated operation planning for sheet-metal bending orientated to graphical programming

Numerical Modeling of Parameters Optimization of Sheet Metal Forming in Drawing Process Based on Artificial Neural Network

Application of Machine Learning to Bending Processes and Material Identification

Prediction of Spherical Sheet Springback Based on a Sparrow-Search-Algorithm-Optimized BP Neural Network

Physical Logic Enhanced Network for Small-Sample Bi-Layer Metallic Tubes Bending Springback Prediction

Research on Bending Forming Method of Large Diameter-Thickness Ratio Thin-Walled Tubes for Aerospace

Rolled Thickness Prediction for Titanium/Steel‐Clad Plates Based on Combined Method of Theoretical and Neural Network

Influence of Thick Plate Bending Process on Material Strength Distribution in Hydrogenation Reactor Shells

Prediction of wrinkling in thin-walled tube push-bending process using artificial neural network and finite element method

Finite element model simulation and back propagation neural network modeling of void closure for an extra-thick plate during gradient temperature rolling

Towards high-accuracy axial springback: Mesh-based simulation of metal tube bending via geometry/process-integrated graph neural networks

Smart Control of Springback in Stretch Bending of a Rectangular Tube by an Artificial Neural Network

Springback Study on Profile Flexible 3D Stretch-Bending Process Using the Neural Network

Influence of bending angle function on local thinning defects of roll-formed sheets based on segmental boundary combination optimization

Machine learning (ML) based models for predicting the ultimate bending moment resistance of high strength steel welded I-section beam under bending