Abstract:One of the important failure criteria of press operations in industry for forming simulations is the Forming Limit Diagram (FLD). The complex loading effects on FLD, in particular the localized necking phenomenon under stretch-bending condition, have not been fully investigated and well understood. In practical sheet metal applications, the deformation is invariably three dimensional with a combination of stretching and bending. For most sheet materials under these complex loading processes used in industry, strong Bauschinger effect is observed, and the material hardening behavior tends to be anisotropic. This study aims to understand and evaluate such anisotropic hardening effect on the forming limit prediction under stretch-bending condition. The extended through-thickness Marciniak–Kuczynski (M–K) analysis is incorporated with Yoshida–Uemori (YU) two-surface kinematic hardening constitutive model, which has a more accurate description of the reverse loading behavior than that of the conventional isotropic hardening model. The material parameters used in this paper for YU model are calibrated with the experimental data from uniaxial large-strain tension-compression cyclic test. Both the isotropic hardening and YU kinematic hardening models with Hill'48 yield surface are employed in the analysis for the purpose of comparison. The Forming Limit Average Stress Diagram (FLASD) under stretch-bending condition is proposed to extend the understanding of Forming Limit Stress Diagram (FLSD) from in-plane to out-of-plane deformations. The “bending-ratio-dependent” phenomenon in forming limit diagram is predicted and observed in both stress/strain space with the proposed method. It suggests that the individual stress/strain state cannot represent system behavior. Forming limits under stretch-bending is suggested as an occurrence of system instability, not individual material instability. The system behavior of sheet metal deformation is reinforced as critical to the understanding of necking instability in stretch bending processes. The analysis shows that the Bauschinger effect provides positive effect in delaying the necking instability, predicting higher formability for sheet metals under stretch-bending. The insight obtained in this paper provides further understanding of the localized necking phenomenon under stretch-bending condition.

Transformation Relation Between Limit Strain and Limit Stress in Sheet Metal Forming

Comparative Analysis Between Stress- and Strain-Based Forming Limit Diagrams for Aluminum Alloy Sheet 1060

Effect of nonlinear strain paths on forming limits under isotropic and anisotropic hardening

Experimental and Numerical Investigation on Sheet Metal Forming Limit Prediction with Thickness Related Criteria

Effect of Through-Thickness Normal Stress on Forming Limits under Yld2003 Yield Criterion and M-K Model

Forming Limit Evaluation by Considering Through-Thickness Normal Stress: Theory and Modeling

Experimental Methodology for Obtaining the Flow Curve of Sheet Materials in a Wide Range of Strains

Prediction of Forming Limits for Anisotropic Materials with Nonlinear Strain Paths by an Instability Approach

A Forming Limit Curve (FLC)Fitting Method Considering Reliability

Prediction of Strain Path Changing Effect on Forming Limits of AA 6111-T4 Based on a Shear Ductile Fracture Criterion

Theoretical failure investigation for sheet metals under hybrid stretch-bending loadings

Forming limit of hot-rolled high-strength steels considering sheet thickness effect

Sheet metal forming limits under stretch-bending with anisotropic hardening

Three-dimensional forming limit diagram for fluid pressure forming of tubes

Forming Limits under Stretch-Bending Through Distortionless and Distortional Anisotropic Hardening

M–K Analysis of Forming Limit Diagram under Stretch-Bending

Forming Limit Evaluation with Perturbation Approach Considering Through-Thickness Normal Stress

Prediction of FLD for sheet metal by considering through-thickness shear stresses

Research on Forming Limit Stress Diagram of Advanced High Strength Dual-Phase Steel Sheets

Investigation and comparative analysis of plastic instability criteria: application to forming limit diagrams

A new forming limit test method for incremental stretch flanging