Abstract:The thread and spline synchronous rolling (TSSR) process is a new developed rolling process, which can form the different profiles simultaneously in the process and can ensure the consistency of the relative position of different profiles of parts. However, the multi-meshing motions are intercoupling and the multi-deformation characteristics are intercoupling during the forming process. It can easily result in dimension overshoot, and even does not make the synchronous rolling process go smoothly. Exploring the influence of controllable processing parameters on the synchronous rolling process, especially the geometric parameters of rolled parts, is helpful to determine the parameters and control the size error for a smooth rolling process. Thus, in this paper, the effects of controllable geometric parameters and motion parameters such as billet diameter, radial feed-in speed, and rotational speed of synchronous rolling die on the TSSR process have been studied. The synchronous rolling experimental scheme was determined using an orthogonal experimental design method, and the geometric parameters of different tooth profiles of rolled parts were measured and analyzed. The experimental results indicated that: the uncoordinated meshing movement between different tooth profiles is more likely to cause tooth error of the splined section of the part; variations of the processing parameters are more likely to cause fluctuations in the size of the splined section of the part, and change of the billet diameter mainly affects the outside diameter of the threaded and splined sections, and the threaded and splined pitches are mainly affected by the motion parameters of the synchronous rolling die; the motion parameters of the rolling die should be matched and the lower rotational speed needs to match the lower radial feed-in amount per revolution; the ideal dimensional accuracy can be obtained by using an appropriate processing parameter combination, for example, the pitch error of the splined section of the part is less than 0.5 μm under one set of experimental conditions in this paper.

Effects of Parameters on the Distributions of Stress and Strain of Multiprocess Draw-Spinning

Effects of Forming Parameters on Deformation Uniformity of Thin-walled Parts during Multi-pass Spinning

Numerical Investigation of Effects of Deformation Allocation on Multi-Pass Conventional Spinning Process of Curvilinear Generatrix Parts

Plasticity Improvement of Ball-Spun Magnesium Alloy Tube Based on Stress Triaxiality

A Study of Multi-Pass Scheduling Methods for Die-Less Spinning

Finite Element Analysis of Stress and Strain Field in Thin-wall Taper Workpiece During Spinning Forming

Effects of spinning parameters on microstructures of ellipsoidal heads during marginal-restraint mandrel-free spinning

Effects of Processing Parameters and Tool Geometric Parameters on Residual Stress of Machined 304 Stainless Steel

Numerical analysis of effect of material and processing parameters on thickness distribution during superplastic die bulging of cavity sensitive materials

Numerical Simulation of Influences of Process Parameters on the Spinning Moment and Quality of Double-Roller Clamping Spinning

Research on the Influence of Main Spinning Process Parameters on the Forming Quality of 20 Steel by Strong Spinning

A Numerical Study of the Effects of Roller Paths on Dimensional Precision in Die-Less Spinning of Sheet Metal

Study on the Effects of Forming Parameters on the Plastic Flow of Axisymmetrical Curved Parts in Stamping Process

Multi-pass Spinning of Thin-Walled Tubular Part with Longitudinal Inner Ribs

Simulation and Discussion on the Decreasing Flow Stress Scale Effect

The effect of microstructure parameters on the residual stresses in the ultrafine-grained sheets

Influence of Process Parameters on Wedging-Spinning of Conical Cup Parts with Bottom Flanges

Numerical Study of Melt-Spinning Dynamic Parameters and Microstructure Development with Ongoing Crystallization

Influence of Processing Parameters on the Thread and Spline Synchronous Rolling Process: an Experimental Study.

Coupling Analysis on Microstructure and Residual Stress in Selective Laser Melting (SLM) with Varying Key Process Parameters

A Systematic Study on the Effects of Process Parameters on Spinning of Thin-Walled Curved Surface Parts With 2195 Al-Li Alloy Tailor Welded Blanks Produced by FSW