Abstract:Brake-by-wire systems are one of the key components in intelligent/unmanned vehicles that have attracted worldwide attention. Testing and evaluation of brake-by-wire systems are a significant step during the development of the technology of vehicular braking and further the advancement of intelligent/unmanned vehicles. Using the test bench to simulate different road adhesion coefficients (i.e. road surfaces) and to complete the testing and evaluation of the vehicle braking systems is of great significance and importance. A test bench for simulation of vehicular braking of 1/4 vehicle is presented and investigated in this article. It is composed of a motor, two rollers, a 1/4 vehicle suspension system, a magnetic powder clutch, a flywheel, sensors, a signal acquisition and processing system, and a controller. The wheel and vehicle speeds are simulated by the rollers and flywheel speeds, respectively. The translational kinetic energy of 1/4 vehicle is simulated by the rotational kinetic energy of the flywheel. The signal acquisition and processing system is used to acquire and process the experimental signals, such as rotational speeds and torques during tests. The magnetic powder clutch with adjusted applied currents in the test bench is used to real-timely simulate roads with different adhesion coefficients. Based on the working principle of the test bench and the fundamentals of vehicle dynamics, the prototype of the test bench is established and the simulation approach of the translational kinetic energy of 1/4 vehicle is investigated. The mathematical model of the real-time simulation about roads with different adhesion coefficients based on the magnetic powder clutch with real-time controllable transmitted torque is established. With the built 1/4 vehicle braking systems based on the test bench and road, and the corresponding established models, the comparison and analysis of the simulation results of various road surfaces are conducted. Experiments are sequentially implemented to verify the feasibility and effectiveness of the test bench.

Comparison of Measuring Methods of Braking Force between Washboard-type Tester and Roller-type

Experimental Study on Air-Hydraulic Brake System

An Experimental Study on Hysteresis Characteristics of a Pneumatic Braking System for a Multi-Axle Heavy Vehicle in Emergency Braking Situations

Research on performance test and control system for driving axle

Loading Design for Comprehensive Performance Test Bench of Drive Axle Assembly

Research on test method and equipment of tractor's braking performance

Study on a Testing Device of Automobile Brake Drum Running-In and Braking Force

Tester for measuring weight difference threshold by constant stimulus method

Hydraulic Controlled Reciprocating Tester Applied to measure the Static Friction

Research on Measurement Principle and Key Measuring Devices of Pressure Change Rate for Electronically Controlled Pneumatic Brake of Commercial Vehicle Based on Poiseuille’s Law

Experiment on Hydraulic Disk Brake Model

Study on Disc Brake Co-simulation for Motorcycle Braking Performance

The Measurement for Performance Parameter of Automobile Braking System with Electronic Vacuum Booster

Investigation and Modelling of the Weight Wear of Friction Pads of a Railway Disc Brake

A Quasi-Actual Mechatronic Instrument for Realistically Testing Roller-Piston Friction Pairs

Design, modeling, and verification of a test bench for braking simulation of 1/4 vehicle

Comparison of Chase and inertial brake Dynamometer testing of automotive friction materials

Simulation Research on Brake and Release Performances for the TMB60 Brake Equipment

Study of the Friction and Vibration Characteristics of the Braking Disc/pad Interface under Dry and Wet Conditions

An Analysis on Control Method of the Brake Test Bench

fBrake, a Method to Simulate the Brake Efficiency of Laden Light Passenger Vehicles in PTIs While Measuring the Braking Forces of Their Unladen Configurations