Abstract:To study the pile-forming mechanism and bearing deformation characteristics of continuous flight auger (CFA) piles, a series of procedures, including helical drilling, pulling up/grouting, and inserting cage/pile forming, were simulated in clay-sand double-layer foundations by a homemade model drilling machine system in laboratory model tests. The effects of two different pile-forming methods on the load transfer and bearing characteristics of the piles were investigated by performing a model test comparison of CFA piles and bored piles. The experimental results show that there exist a soil improvement effect around the pile and a diameter expansion effect during the drilling process and grouting process for the CFA pile, which can effectively improve the lateral friction resistance of the pile. Compared with the bored pile, the pile diameter in the middle of the CFA pile increased by 19%, and the total lateral friction resistance of the CFA pile increased by 9.1% at a high load (1500 N). The comparative results of the model tests show that the bearing capacity of a single CFA pile increased by 50.0% and that the total settlement decreased by 40.5%. The results of the in situ test piles show that the load-settlement curves of the two pile types are similar under low-medium loads and that the lateral friction resistance of the CFA pile under high loads is better developed, which is relatively consistent with the model test results.

Experimental study on bearing capacity property of cement-soil pile group in situ

Experimental Study on Behavior of Composite Foundation with Rigid-Flexible Piles

In-situ test of bearing capacity behavior of composite foundation with rigid-flexible piles

Experimental Analysis of Bearing Capacity of Cast-in-place Tubular Pile

Test Research on the Behavior of Composite Foundations Incorporating Rigid and Flexible Piles

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Influences of different replacement ratios on composite foundation with rigid-flexible piles

Model Test Study of Bearing Behavior of Small Prefabricated Piles in Soft Soil Area

Numerical Study of the Effect of Material Modulus Upon Cement-Soil Pile Composite Foundation

Model tests on the bearing capacity of precast oxen-ended micro pipe plies in sort soil

Field Test on the Influence of the Cemented Soil Around the Pile on the Lateral Bearing Capacity of Pile Foundation

Experimental Study Of The Rigid-Flexible Pile Composite Foundation

Experimental Study on Bearing Capacity Behavior of Deep Large Diameter Cast-in-place Belled Pile

A test on base bearing capacity of static drill rooted nodular pile

Research on In-Situ Tests of Pile Load Transfer Behaviors in Composite Foundation with Rigid-Flexible Piles

Experimental Research on Vertical Bearing Capacity of Composite Piles in Soft Ground

Laboratory Model Study on the Pile-Forming Mechanisms and Bearing Deformation Characteristics of CFA Piles

Experimental study on vertical bearing performance of base post-grouted cast-in-place plies in soft soils

Influence of Soil Reinforcement on the Uplift Bearing Capacity of a Pre-Stressed High-Strength Concrete Pile Embedded in Clayey Soil

Testing and Modeling the Behavior of Pre-Bored Grouting Planted Piles under Compression and Tension

Behavior of Sand Filled Nodular Piles under Compression in Soft Soil Areas