Abstract:The effects of symmetry and orientation of the additional steel rods on the band gaps of two-dimensional phononic crystals with steel-air system are numerically investigated by using the plane wave expansion method. The original steel rods of the phononic crystals are of columns in square and hexagonal lattices, and the additional steel rods are of regular square, hexagon, octagon prisms and columns, which are placed, respectively, in the center of each unit cell of the two kinds of lattices. The gap maps are introduced to illustrate the influences of the filling fraction and orientation of the additional rods on band gaps. It is found that in the case of the additional rods with low filling fraction, the band gaps can be obtained most easily because the degeneracy of bands is lifted when the cross section of additional rod has the same shape as that of lattice, but the widest band gaps appear under the condition of the additional rods with highest symmetry and largest filling fraction. The influence of orientation on band gap in square lattice is more obvious than that in hexagonal lattice. If the column lattice points are changed by square prisms in simple square lattice, the lower and wider band gaps can be produced by rotating the square prisms, which is contrary to the scenario that emerges in square lattice with additional rods at the center of unit cell. Using one of the methods of adding additional rods or rotating the original prisms is more beneficial to the generation of band gaps than combining effect of these two means in simple lattices. Furthermore, the mechanisms of above results are analyzed.

Effect of Stuffing Rate on the Band Gap Structure of the Finite Height Photonic Crystals

Effect of Structure Parameter on Complete Bandgap of Two-Dimensional Long Wave Infrared Photonic Crystal

Theoretical Analysis of Optimum Parameters for Complete Forbidden Bands of Three-Dimensional Photonic Crystals with Typical Lattice Structures

Properties of Photonic Bandgap in One-Dimensional Mutlicomponent Photonic Crystal

Large Absolute Band Gaps in Two-Dimensional Photonic Crystals Formed by Large Dielectric Pixels

Effect of the Ratio of Hole Radius to Lattice Spacing on Transmission Characteristics for Metal/Dielectric Photonic Crystal

Effect of Number of Unit Cells of Fcc Photonic Crystal on Property of Band Gaps

Study of Band Gaps of Two-Dimensional Phononic Crystals with Criss-Crossed Elliptical Holes

A New Method of Modeling Cladding Band Structure of Air-Guiding Photonic Crystal Fibers

Tuning of Band Gaps for a Two-Dimensional Piezoelectric Phononic Crystal with a Rectangular Lattice

Band Gap Widening by Photonic Crystal Heterostructures Composed of Two Dimensional Holes and Diamond Structure

Maximizing Band Gaps in Two-Dimensional Photonic Crystals in Square Lattices.

The ultra-wide band gap property induced by lattice period gradually changing in three-dimensional photonic crystals

A Two-Dimensional Photonic Crystal Formed by a Triangular Lattice of Square Dielectric Rods with a Large Absolute Band Gap

The Two-Dimensional Phononic Crystal Band Gaps Tuned by the Symmetry and Orientation of the Additional Rods in the Center of Unit Cell

Transmission properties of a two-dimensional photonic crystal in a dielectric constant supercell

NUMERICAL STUDY ON PHOTONIC PROPERTIES IN TWODIMENSIONAL COMPLEX PHOTONIC CRYSTALS OF SQUARE LATTICE

Study of the Photonic Crystal Waveguide Based on 2D Compound Lattice Structure

Band gap of two-dimensional layered cylindrical photonic crystal slab and slow light of W1 waveguide

Large One-Dimensional Band Gaps in Three-Component Phononic Crystals Plates

Existing conditions of full bandgaps and absolute negative refraction in metallic-dielectric photonic crystal