Abstract:Aeolian sand transport caused by soil wind erosion is a serious problem in many arid regions in the world, and it is considered to be the significant part of global biogeochemical cycles. The dust produced by aeolian sand transport can affect the atmospheric radiation balance, climate, the environment, air quality, and human health. Therefore, widespread attention has been attracted to the significance of aeolian sand transport for geomorphology, climatology, meteorology, ecology and environmental science. Sand sampler is an important instrument to measure the quantity of aeolian sand caused by wind erosion, and there were many sand samplers designed and used in wind tunnel and field experiments for measuring aeolian sand. Sampling efficiency is an important parameter for correcting the quantity of aeolian sand collected by sand sampler, its value depends on the structures of sand sampler, wind speed during measurement process, sand particle size and measuring time. The sand-dust horizontal flux is an important parameter for the study on aeolian sand transport, as well as an important foundation. The research on sand-dust horizontal flux can enhance our understanding of soil wind erosion, aeolian sand transport and wind sand disasters. The Taklimakan Desert is the second largest shifting sand desert in the world, with about 85% of its environment made up of shifting sand dunes, and it is known to be an important dust source area that contributes to the high incidence of dusty weather in China. There is an annual average of more than 100 days of dusty weather in the desert, and in some stations this figure can be over 200. It is a huge testing platform for field experiment of aeolian sand transport.In this study, a field experiment was developed to measure the data of aeolian transport and microclimate during different dust events with a auto sand sampler, a piezoelectric saltation sensor (Sensit, H11B) and a 10 m high meteorological tower in Tazhong, the hinterland of the Taklimakan Desert from July to August in 2010. Then the sampling efficiency of auto sand sampler and horizontal dust flux of near surface were analyzed based on observed data. The results showed that: There was a good linear relationship between the amount of sediment and total saltation particle numbers, and the average value ofR2 was 0.6053. The average sampling efficiency of atuo sand sampler was 94.3% at 5 cm high. The horizontal dust flux of different dust events that passed through a section of 100 cm in width and 200 cm in height was calculated with formulaQ=256 m, the maximum of one dust event was about 190.335 kg, and the minimum was 1.2 kg. Overall, the sand transport rate increased with wind speed. However, the changes of sand transport rate did not quite fit in with wind speed during some dust events, and in this case the corresponding surface temperature was significantly higher. The experimental data obtained can provide theoretical basis for regional sand control and enacting effective engineering measures.

Study on the Dust Environment Based on Tribology

Tribology in Natural Sand Dust Environment

Experiment on Dust Flux During Duststorm Periods over Desert Area

Tribological behavior of carbon steel 45 and brass H90 in dry sliding on bearing steel GCr15 in the sand-dust environment

Composition Variation of PM10 During a Dust Storm Episode in Lanzhou, Northwestern China

Relationships Between Near-Surface Horizontal Dust Fluxes and Dust Depositions at the Centre and Edge of the Taklamakan Desert

Influence of Topographic Relief on Sand Transport in the Near-Surface Layer During Dust Storms in the Taklimakan Desert

Variability of Dust Mass Concentrations and Deposition Rates under Different Weather Conditions in Cele Oasis, Southern Tarim Basin

Chemical Modification of Dust Particles During Different Dust Storm Episodes

Analysis of Horizontal Flux and Sand Collecting Efficiency of Sand Dust Near Ground Surface Based on Field Observations

Microscopic characteristics and sources of atmospheric dustfall in open-pit mining coal resource-based city in the arid desert area of Northwest China

Study on Dynamic Contact Behavior of Multi-Component Droplet and Dust Surface

Observed Particle Sizes and Fluxes of Aeolian Sediment in the Near Surface Layer During Sand-Dust Storms in the Taklamakan Desert

Composition Characteristic and Surface Charge Simulation of Atmospheric Dust Fall in Tianshui City

Based on the Earth's Surface Layer Dust Flux Field Observation and Study on Collection Efficiency

Field Observations on the Turbulent Features of the Near-surface Flow Fields and Dust Transport During Dust Storms

Research on Threshold Friction Velocities During Dust Events over the Gobi Desert in Northwest China

Investigating the impact factors of dust emission efficiency over gobi with portable wind tunnel field experiments

Magnetic Characteristics of Atmospheric Dustfall in a Subtropical Monsoon Climate Zone of China and Its Environmental Implications: A Case Study of Nanjing

Characterization of Mineralogy and Surface Zeta Potential of Atmospheric Dust Fall in Northwest China

Dust storm susceptibility on different land surface types in arid and semiarid regions of northern China