Study on Dynamic Contact Behavior of Multi-Component Droplet and Dust Surface

Jingzhong Guo,Longzhe Jin,Yuanzhong Yang,Ruoyu Cui,Naseer Muhammad Khan,Ming Li,Qipeng Zhang,Xinran Yue
DOI: https://doi.org/10.3390/coatings13071146
IF: 3.236
2023-06-24
Coatings
Abstract:The dynamic contact behavior between multi-component droplets and the surface of iron ore dust was taken as the research object, analysis of the maximum spreading coefficient, maximum acting diameter, maximum acting area, and maximum bouncing height of solid-liquid contact, from a microscopic perspective, using high-speed photography and image analysis and processing technology. The experimental results indicate that (1) with the particle size of dust particles decreases, the solid-liquid contact behavior sequentially manifests as spread immediately after broken, retraction, negative bounce, primary bounce, and secondary bounce. (2) When the surface tension of the droplets decreases from 55.5 to 34.8 mN/m, the maximum spreading diameter of the droplet has increased by 30% to 40%, the maximum bounce heights (coefficients) decreased by 100%, 57.14%, and 53.57%, respectively, the maximum spreading coefficient of the droplet exhibits no obvious pattern. (3) With decreasing droplet surface tension, the unidirectional acting diameter and the maximum acting area increase when the dust surface size is over 100 μm. When the surface particle size is less than 100 μm, there is no significant change in the unidirectional acting diameter and maximum acting area despite decreasing surface tension. Thus, droplet diffusion is mainly influenced by particle size. These findings contribute to enhancing the theory of water mist dust removal and improving dust removal efficiency.
materials science, multidisciplinary,physics, applied, coatings & films
What problem does this paper attempt to address?
The paper aims to study the dynamic contact behavior between multi-component droplets and the surface of iron ore dust. Specifically, using high-speed photography and image analysis processing techniques, it analyzes parameters such as the maximum spreading coefficient, maximum contact diameter, maximum contact area, and maximum rebound height of solid-liquid contact from a microscopic perspective. The main objectives are: 1. **Experimental Study**: To experimentally study the differential characteristics under different dust particle sizes and surface tension conditions. 2. **Optimization of Wetting Agent Formulation**: To optimize the wetting agent formulation based on experimental results to improve dust removal efficiency. These findings help to enhance the theory of water mist dust removal and improve dust removal efficiency.