Abstract:Eddy current damping has been widely applied in mechanical engineering; however, its adaptation for civil engineering applications remains rather limited due to its low density of energy dissipation. This study presents the development of a new type of eddy current damper and theoretical and experimental characterization of its damping properties. In addition to rectangular permanent magnets and conductive plate, both primary back iron and secondary back iron are considered in the proposed eddy current damper, which represents an improved design over previous configurations. The analytical method based on the charge model of permanent magnets is extended to simulate the extra damping effect of the primary back iron and secondary back iron, and the magnet field and damping properties of the dampers are evaluated analytically. The use of a back iron in the proposed damper is shown to increase the damping coefficients by a factor of up to 5. The analytical results are compared with those obtained with the finite-element analysis in terms of accuracy in magnetic field distributions, eddy current distributions, and damping coefficients. The linear assumption, which implies the damping force is linearly proportional to velocity in the analytical model, is also examined for different motional velocities and relative permeability of the permanent magnet. It is shown that the linear damping assumption in the analytical model is only valid for a limited range of low velocity, and this velocity range can be increased by reducing the thickness or conductivity of the conductive plate. In addition, a modification is needed for the analytical model if the relative permeability of the permanent magnet significantly deviates from the assumed value of 1.0. Finally, the accuracy of the analytical model and the finite-element model is verified by experiment of a prototype damper mounted in a laboratory steel frame.

Research on Damper with Multilayer Steel Plates Modeling and Simulation of Isolation System

A Simplified Analytical Model for U-shaped Steel Dampers Considering Horizontal Bidirectional Deformation

Research On Dynamic Characteristics Of A Magnetorheological Damper With Decoupling Mechanism

Simulation And Design Of Composite Vibration Isolator For Spacecrafts

Experimental Research on Thickness Influence on Isolation Characteristics of Multilayer Circle Metal Plate Damper

Modeling of Micro-Friction in A Multi-Layer Metal Plate Damper for A Rotor Support System

Calculation of Multi-Layer Plate Damper under One-Axial Load

Experimental research on special multi-layer steel plate isolator

Dynamics of A Passive Micro-Vibration Isolator Based on A Pretensioned Plane Cable Net Structure and Fluid Damper

Finite Element Modeling of Nonlinear Active and Passive Dampers Applied to Vibration Controls

Modeling and Analysis of A Novel Planar Eddy Current Damper

Experimental study on lateral performance of slotted U-shaped steel damper

Effect of Viscous Heating in Fluid Damper on the Vibration Isolation Performance

Experiment Research and Nonlinear Analysis to Visco-Elastic Damping Structure for Whole-Spacecraft Passive Vibration Isolation System

Numerical Analysis of Multi-degree of Freedom Isolation Structures with ER Dampers

Modeling and Applications of Variable Structure Damper

Effect of Steel Belt Thickness on Stiffness Charictoristics of Multilayers Waveshape Rotor Damper

Performance Simulation Analysis and Comparison of Different Shearing Mild Steel Dampers

Design and Modeling of a Novel Double-Piston Magnetorheological Damper

Analytical development and experimental investigation of the casting multi-plate damper (CMPD)

Modeling, Testing, and Validation of an Eddy Current Damper for Structural Vibration Control