Abstract:In various industrial processes, solid-liquid multiphase flows involving continuous carrier and discrete particle phases have erosion challenges. In this work, a modified drag model that considers the influence of turbulence intensity and a modified erosion model that considers the effect of low-angle impact are developed. An improved method combined modified drag model and modified erosion model based on LES is proposed for numerical simulation of solid-liquid multiphase flow and erosion. The commercial software ICEM for grid generation and ANSYS FLUENT for LES are used in the present work. In validation test of velocity distribution of solid-liquid multiphase flow in a vertical pipe, the mean relative error of the liquid phase pulsation velocity is 10.01 % for modified drag model, whereas the mean relative error is 16.11 % for original drag model. In validation test of the maximum erosion depth from a submerged impact test at a tilt angle of 45 degrees, the relative error is 0.23 % for modified erosion model, while the relative error is 13.39 % for original erosion model. Then, the improved method is employed to compute the characteristics of solid-liquid flow and erosion in a 90 degrees elbow. Particles have a significant influence on liquid flow in the shear layer area where the inner arch separation zone interacts with the main flow, and this influence is most pronounced at the position of r* = 0.3 at yd = 0.4D. At this position, particles result in 15.27 % reduction in liquid velocity and 8.75 % increase in turbulence intensity. The mean relative error of the elbow erosion rate by using the improved method is 16.95 %, whereas it is 31.34 % of the reference work. The erosion is affected by impact velocity, angle, and particle number, and the most significant parameter is the particle number in the severe erosion area.

Effect of Secondary Flow on Erosion from Solid Particles in 90°Curved Duct of Quadrate Section

Numerical Study of Solid Particle Erosion in a Cavity with Different Wall Heights

Numerical simulation research for the effect of particle shape on the erosion wear in elbow

Coarse-grained CFD-DEM Simulation of Elbow Erosion Induced by Dilute Gas-Solid Flow: A Multi-Level Study

Numerical Simulation of the Secondary Flow in a Curved Duct of Squareshaped Cross-section

Numerical study of solid particle erosion on sidewall

Effects of Finite-Size Heavy Particles on the Turbulent Flows in a Square Duct

Three-dimensional numerical investigation of solid particle erosion in gate valves

Research On Reducing Erosion By Adding Ribs On The Wall In Particulate Two-Phase Flows

The effect of coherent vortex structure in the particulate two-phase boundary layer on erosion

Numerical simulation of the erosion in the 90° elbow

Modeling of liquid-solid flow erosion in curved pipes of gradually varying cross section

Influence of gravity on secondary flow of particle phase in a square duct

Numerical simulation of sand erosion in Venturi tube under different flow characteristics and sand content

Numerical prediction of solid particle erosion in angle-cutting elbows with gas-solid flow

Numerical Study of the Solid Particle Erosion on H-Type Finned Circular/Elliptic Tube Surface

Gas-particle flow and erosion in bends with a rectangular cross-section

Numerical Computation of Particle-Laden Gas Flows Past Staggered Tube Banks Undergoing Erosion

An Improved Method Combined Modified Drag Model and Modified Erosion Model Based on LES for Solid-Liquid Multiphase Flow and Erosion with Application in a 90° Elbow

Numerical Study of Solid Particle Erosion on the Tubes Near the Side Walls in A Duct with Flow Past an Aligned Tube Bank

Experimental and Numerical Investigation on Erosion of Circular and Elliptical Immersed Tubes in Fluidized Bed