Abstract:This paper proposes a novel methodology to improve stability in a transmission system under critical conditions of operation when additional loads that take the system to the verge of stability are placed in weak bus bars according to the fast voltage stability index (FVSI). This paper employs the Newton–Raphson method to calculate power flows accurately and, based on that information, correctly calculate the FVSI for every transmission line. First, the weakest transmission line is identified by considering N−1 contingencies for the disconnection of transmission lines, and then all weak nodes associated with this transmission line are identified. Following this, critical scenarios generated by stochastically placed loads that will take the system to the verge of instability will be placed on the identified weak nodes. Then, the methodology will optimally size and place a single static VAR compensator SVC in the system to take the transmission system to the conditions before the additional loads are connected. Finally, the methodology will be validated by testing the system for critical contingencies when any transmission line associated with the weak nodes is disconnected. As a result, this paper's methodology found a single SVC that will improve the system's stability and voltage profiles to similar values when the additional loads are not connected and even before contingencies occur. The methodology is validated on three transmission systems: IEEE 14, 30, and 118 bus bars.

Optimal Location of Static Var Compensators and Phase Shifters and Their Impact on the Generation and Transmission System Reliability

Optimal Allocation of Dynamic Var Sources for Reducing the Probability of Commutation Failure Occurrence in the Receiving-End Systems

Analysis, Control and Optimal Placement of Static Synchronous Compensator With/without Battery Energy Storage

Optimal Adjustment of Power Network Structure by Considering Static Voltage Stability and Short-Circuit Current Level of Multi-Infeed DC Systems

Analyses of Static and Dynamic Reactive Power Allocation Between Synchronous Compensators and Shunt Capacitors to Counter Commutation Failures

Global Approximation of Static Voltage Stability Region Boundaries Considering Generator Reactive Power Limits

Research on optimal placement of FACTS devices based on reliability cost/benefits analysis

Optimal Placement of Shunt Connected Facts Device in a Series Compensated Long Transmission Line

Reliability assessment of power systems considering reactive power sources

Interaction Analysis of SVC and STATCOM Controllers Based on RGA Principle

Reliability Evaluation Model of Composite Generation and Transmission System Incorporating FACTS Devices

Optimal Placement of Dynamic Reactive Power Compensation Devices for Improving Immunity to Commutation Failure in Multi-Infeed HVDC Systems

A Novel Steady-state Voltage Stability Enhancement Method Based on SVC Allocation

Voltage-Sag-Severity-Index Based Size Planning of Shunt Capacitor Banks to Improve Short-Term Voltage Stability

Optimal Planning of Dynamic VAR Compensation Based on Transient Voltage Stability Analysis

Optimal allocation of multi-type FACTS devices in power systems based on power flow entropy

A Dynamic VAR Configuration Method Based on Improved Trajectory Sensitivity Index

Optimal Allocation Method of Dynamic Var Compensation Based on Transient Voltage Stability Index

Research on Optimal Allocation of Reactive Power Compensators in Substation

Optimal Placement and Sizing of Fault Current Limiters: A Voltage- Stability-Constrained Approach Considering Transmission Switching

Optimizing Critical Overloaded Power Transmission Lines with a Novel Unified SVC Deployment Approach Based on FVSI Analysis