Abstract:This study examines the effects of laser shock peening parameters on the structural, mechanical, tribological, and corrosion properties of AA5052 aluminum alloy. The LSP process uses specific parameters, detailed in Table 2, to induce ultra-high plastic strains and strain rates in the material. The research demonstrates significant improvements in both surface hardness (48.29% increase) and tensile strength (24.63% increase) for the optimized LSP conditions. The treatment results in a maximum compressive residual stress of 231.02 MPa near the surface, concentrated within a depth of 100 μm. X-ray diffraction analysis reveals the formation of Mg 2 Al 3 (β) precipitates on the LSP surface, along with peak broadening and shifting indicative of residual stress. These precipitates, along with the high dislocation density caused by severe plastic deformation during LSP, are contributed to the enhanced mechanical properties. Electron backscatter diffraction and transmission electron microscopy observations on the LSP-treated AA5052 confirm the introduction of dislocation shifts, deformation twins, and refinement of grain structure. Additionally, the LSP treatment (1.046 × 10 −3 mm/N-m 3 ) significantly improves wear resistance compared to unpeened alloy (4.482 × 10 −3 mm/N-m 3 ), with a wear rate reduction of over 76.6% during the linear reciprocating tribometer. Finally, electrochemical corrosion tests demonstrate superior corrosion resistance in LSP-treated AA5052 (corrosion rate of 0.0116 mm/yr) compared to the unpeened alloy (0.0551 mm/yr). This study demonstrates that LSP significantly enhances the mechanical performance and corrosion resistance of AA5052 alloy, establishing it as a valuable candidate for shipbuilding applications that require superior durability.

Research of Strengthening 7050 Aerial Aluminum Alloy Structural Material with Laser Shock Processing

Microstructure and residual stress modulation of 7075 aluminum alloy for improving fatigue performance by laser shock peening

Effect of laser shock peening on the high-temperature fatigue performance of 7075 aluminum alloy

Laser shock peening regulating aluminum alloy surface residual stresses for enhancing the mechanical properties: Roles of shock number and energy

Analysis of microstructure and high-temperature tensile properties of 2060 Al-Li alloy strengthened by laser shock peening

Relationship between Stress State and Microstructure of 7B04 Aluminum Alloy Surface Fatigue Properties by Laser Shock Peening Improvement

Enhanced fatigue strength of 2A02 aluminum alloy via micro laser shock peening

Effects of laser shock peening on fatigue crack growth rate and fracture properties of AA2524 aluminum alloy

Investigation of the surface qualities of laser shock-processed zones and the effect on fatigue life of aluminum alloy

Experimental and Numerical Studies of Fatigue Behavior of Ti6Al4V Alloy Treated by Laser Shock Peening

Laser shock processing of aluminium alloys. Application to high cycle fatigue behaviour

Unraveling Residual Stress Distribution Characteristics of 6061-T6 Aluminum Alloy Induced by Laser Shock Peening

The effect of laser shock peening on very high cycle fatigue properties of laser welded 2A60 aluminum alloy joints

Fatigue life and fracture evolution of small-hole specimens by laser shock processing

Influencing laser shock peening treatment of the mechanical, tribological, corrosion, and microstructural characteristics on AA5052 alloy

Laser shock-processing for fatigue and fracture resistance

Laser shock peening induced mechanical properties enhancement of 50CrVA alloy

Microstructure and Fatigue Performance of Hard Al Alloy Repaired by Supersonic Laser Deposition with Laser Shock Peening Treatment

Comparison of Mechanical and Corrosion Properties of 7050 Aluminum Alloy after Different Laser Shock Peening

Microstructural evolution and mechanical behaviors of Al-Cu-Li alloy processed by laser shock peening

The effect of laser shock processing on the microstructures and properties of 2060 Al Li alloys