Abstract:A two-phase thermo-siphon loop for removing nuclear heating and maintaining the stable liquid level in the moderator cell was adopted for the cold neutron source (CNS) of the China advanced research reactor (CARR). The moderator is liquid hydrogen. The two-phase thermo-siphon loop consists of the crescent-shape moderator cell, the moderator transfer tube, and the condenser. The hydrogen is supplied from the buffer tank to the condenser. The main feature of the loop is that the moderator cell is covered by the helium sub-cooling system. The cold helium gas from the helium refrigerator is firstly introduced into the helium sub-cooling system and then flows up through the tube covering the moderator transfer tube into the condenser. The main part of this system is installed in the CNS vertical channel made of aluminum alloy 6061 T6 (Al-6061–T6) of 6mm in thickness, 270mm in outer diameter and about 6m in height. For confirming the safety of the CNS channel, the combustion tests using a tube compatible with the CNS channel were carried out using the hydrogen–air mixture under which air is introduced into the tube at 1 atmosphere, and then hydrogen gas is supplied from the gas cylinder up to the test pressures. And maximum test pressure is 0.14MPaG. This condition is involved with the maximum design basis accident of the CARR–CNS. The peak pressure due to combustion was 1.09MPa, and the design pressure of the CNS channel is 3MPa. The safety of the CNS was thus verified even if the maximum design basis accident occurs. The pressure and stress distributions along the axial direction and the displacement of the tube were also measured.

Mockup Tests of Void Fraction in Moderator Cell and Two-phase Thermosiphon Loop of Cold Neutron Source in China Advanced Research Reactor

Thermal hydraulic tests for developing two-phase thermo-siphon loop of CARR-CNS

Simulation Study for the Influences of Fluid Physical Properties on Void Fraction of Moderator Cell of Cold Neutron Source

Conceptual Design and Feasibility Test of Two-Phase Hydrogen Thermal Siphon System of CNS in CARR

Study on void fraction distribution in the moderator cell of Cold Neutron Source systems in China Advanced Research Reactor

Mock-up Tests on the Combustion of Hydrogen–air Mixture in the Vertical Tube Simulating the CNS Channel of the CARR

Feasibility Analysis of Single-phase Moderator Cell in CARR Cold Neutron Source

Design of Cold Neutron Source(CNS) in China Advanced Research Reactor(CARR)

Thermal and Mechanical Characteristics of the Moderator Cell in A Cold Neutron Source

Design and Analysis of A Moderator Cell Structure for Carr Cns

Method to Reduce Void Fraction in the Neutron Moderator Cell of CARR CNS

Strength Analysis of CARR-CNS with Crescent-Shape Moderator Cell and Helium Sub-Cooling Jacket Covering Cell

Experimental Investigation of Two-Phase Countercurrent Flow Limit in Hydrogen Thermosiphon Loop of Cold Neutron Source

Evaluation of the void fraction in the crescent-shape moderator cell of the CARR-CNS

Heat Transfer Research on a Special Cryogenic Heat Exchanger-a Neutron Moderator Cell (NMC)

EXPLORATION OF MATHEMATIC MODEL ON VOID FRACTION OF MODERATOR CELL OF COLD NEUTRON SOURCE

Three Dimensional Numerical Simulation of Thermal-Hydraulic Behaviors of CSNS Decoupled Poisoned Hydrogen Moderator with Non-Uniform Heat Source

Development of a Steady Thermal-Hydraulic Analysis Code for the China Advanced Research Reactor

The Calculation of Mass Flux Distribution of CARR

Study of W/Cu Flat-Type Mock-Ups with Novel Hypervapotron Cooling Structure for CFETR Divertor

Analysis on Natural Circulation Capacity of the CARR