Abstract:The sole micropores strictly restrict the wide utilization of TS-1 zeolite in the catalytic fields, especially in the catalytic conversion of compounds with large molecular sizes. Here, we report a feasible and economical method to overcome this drawback. In this work, the hierarchical TS-1 zeolite was constructed via post-acid treatment, post-alkali etching, and a combination of post-acid treatment and alkali etching methods, after which, the corresponding NiMo-supported catalysts were prepared via the incipient wetness impregnation method. Then, the aforementioned materials were fully characterized using X-ray diffraction (XRD), N-2 adsorption-desorption, pyridine adsorbed Fourier transform infrared spectroscopy (Py - FTIR), H-2 temperature programmed reduction (H-2 - TPR), X-ray photoelectron spectroscopy (XPS), and high-resolution transition electron microscope (HR-TEM) to unravel the changes in the physicochemical properties caused by the post treatments. Finally, the hydrodesulfurization of dibenzothiophene (DBT) was used as a probe to assess the effects of the post-treatments on the catalytic performance of the hierarchical NiMo/TS-1 catalysts. The results showed that the MFI topology of TS-1 zeolite remained undamaged significantly and the serial hierarchical TS-1 zeolites exhibited higher specific surface areas and mesopore structures. Moreover, appropriate amounts of Bronsted acid sites were formed at the surface of the serial hierarchical TS-1 zeolites. The interaction between the active metals and the support materials was also modulated by the post-treatment of TS-1 zeolite, which resulted in better dispersion of Ni promoted MoS2 slabs with a higher proportion of NiMoS active phase, further leading to the enhanced catalytic activity and direct desulfurization pathway selectivity of the corresponding serial hierarchical NiMo/TS-1 catalysts. Among all the prepared catalysts, the catalytic activity was enhanced by approximately 1.2 times over catalyst NiMo/AT-TS-1 obtained by post-acid treatment compared to that over catalyst NiMo/TS-1 without treatment and on which the selectivity of the DDS pathway was 22% higher compared to that over catalyst NiMo/TS-1.

Study on the hydrodesulfurization active phase in sulfided NiW/Al2O3 catalyst. II. Temperature-programmed reduction

The Formation of the Active Phases in Sulfided NiW/Al2O3 Catalysts and Their Evolution During Post-Reduction Treatment

Study on the hydrodesulfurization active phase in sulfided NiW/Al2O3 catalyst. III. Low-temperature FT-IR spectroscopy of adsorbed CO

Role of the Solvent Evaporating Temperature on the NiMo/TiO2-Al2O3 Catalyst and the Hydrodesulfurization Performance for 4,6-Dimenthyldibenzothiophehe

Hierarchical TS-1 zeolite loaded with NiMo catalysts: Preparation and performance in hydrodesulfurization

In Situ Synthesis of Nb-modified AFI Topology Molecular Sieve and Its Modulation on the Formantion of High-Efficiency Catalyst for 4,6-Dimethyldibenzothiophene Hydrodesulfurization

Thiophene hydrodesulfurization activities and microstructure of sulfided NiW/γ-Al2O3 catalysts

Effects of Ni Loading and Presulfidation on Reactivity of Thiophene Hydrodesulfurization over NiW/γ-Al2O3 Catalysts

Acid–base Properties of NiW/Al2O3 Sulfided Catalysts: Relationship with Hydrogenation, Isomerization and Hydrodesulfurization Reactions

Study on the active phases of Ni-W system hydrotreating catalysts

Influence of W on Structure and Hydrodesulfurization Performance of W-Ni2 P/SBA-15 Catalysts

Insight into the formation of the active phases in supported NiW hydrotreating catalysts

Ni 2P catalysts supported on titania-modified alumina for the hydrodesulfurization of dibenzothiophene

Influence of Ni on the active phase and hydrodenitrogenation and hydrodesulfurization activities of MoS2 catalysts

Preparation, characterization and hydrodesulphurization catalytic performance of Al-Ni2P/SBA-15 catalysts

ur di ff erent synthetic routes of Ni 2 P / TiO 2 – Al 2 O 3 catalysts for hydrodesulfurization of dibenzothiophene †

Preparation of Ni2P/SiO2 Hydrodesulfurization Catalyst by a Non-Calcination Method

Active Phase of A Niso4 Catalyst Supported on Gamma-Al2o3 During in Situ Self-Sulfidation for Selective Hydrodesulfurization

TPR Study on Hydrodesulfurization Catalysts Supported over Siliceous MCM-41

Ni<sub>2</sub>P Catalysts Supported on Titania-Modified Alumina for the Hydrodesulfurization of Dibenzothiophene

Effect of citric acid on sulfidation behavior of NiW/Al2O3 hydrodesulfurization catalyst