Abstract:Monitoring and analyzing the conditions of aging aerospace or civil structures such as aircrafts, bridges, and buildings are essential to verify structural integrity. The assessment of structural properties and dynamic characteristics of such systems are important to ensure long-term reliability and to determine the right time for component repair or replacement. Recently, improvement in camera technology and image-processing algorithms has made advanced non-contact full-field measurement techniques, such as the digital image correlation method, appealing for non-destructive evaluation and structural health monitoring. With increasing demands for better image quality and noise reduction from external sources, the stability requirements of camera systems for capturing are becoming more rigorous. To reduce the influence of camera micro-vibration on image quality, vibration isolation of the whole camera system must be considered. Therefore, a method to design and optimize a vibration isolation system needs to be developed. This study presents the engineering analysis and testing of a low-cost vibration isolator specifically aimed at vertical high-frequency motion. The device works on the principle of displacement transmissibility reduction by the use of a wave spring and specially designed brackets. The base features a threaded aperture to allow leveling adjustment of the platform. The isolator is fixed on an electromechanical shaker and excited by a swept-sine signal from 0 to 100 Hz with a small sweep rate. We measured the vibration of isolator by two laser sensors to obtain the transmissibility curve during its operation. As a result, the isolator filters out a broad band of input vibration frequencies and ensures a constant level of vibration transmission reduction in the vertical direction. The isolator features a 10 Hz vertical resonance frequency and begins isolating at 13 Hz. The proposed model is stable and performs sufficiently to eliminate 90% of vibration noise, which satisfies the requirement for a high-speed camera system on the ground.

Vibration Analysis of Digital Radiography System for Large Container Inspection

Analysis of Cantilever Vibration of 60co Container Inspection Vehicle

Analysis of Cantilever Vibration of Gamma Radiation System

Performance test of optical and electronic image stabilizer for digital imaging system

Analysis of the Simulation Model Based on Remote Sensing Imaging under Vibration

Analysis of Influence of Mechanical Vibration on Ghost Imaging

NON-CONTACT MEASUREMENT TECHNIQUE FOR DYNAMIC RADIAL DEFORMATION OF EXPLOSION CONTAINMENT VESSELS

Vision-based Structural Displacement Measurement: System Performance Evaluation and Influence Factor Analysis

Dynamic Analysis and Vibration Depression Design of Portable Computer

Dynamic Experimental Investigation On The Self-Vibration Characteristics Of Liquid Storage Tanks Under Seismic Excitations

A Vision-Based System for Dynamic Displacement Measurement of Long-Span Bridges: Algorithm and Verification

Vibration Tests and Crack Analyses on Multi-Storeys Industrial Factory Buildings

Identification of Structural Dynamic Characteristics Based on Machine Vision Technology

Structural Low-Level Dynamic Response Analysis Using Deviations of Idealized Edge Profiles and Video Acceleration Magnification

Vibration Rapid Analysis and Comparison of Motor Support in Container Crane’s Machine Room with Single Degree of Freedom and Finite Element Method Based on Visual Basic

Time and Frequency Analysis of Vibration Signals for Testing Motion Equipment of Lithography

The Research of Beam Center Measurement in Container Inspection System

Measurement of Deformation and Strain Field of Cantilever Beam under Forced Vibration.

Dynamic Analysis of the Structure of a Container Ship

Design and Analysis of Micro-Vibration Isolation System for Digital Image Correlation System-Based Structural Health Monitoring

The resuarch on rectification and amplification of the image in mobile large container inspection system