Abstract:Purposes The research on advanced stratospheric airships in China is mainly at the conceptual design stage, lacking specific mechanical performance evaluation to promote their development. Methods On the basis of the uniaxial cyclic tensile test of airship membrane material, the mechanical performance of the semi-rigid stratospheric airship (L=120 m) with carbon fiber skeletons and inflatable rings was analyzed. The influence of carbon fiber skeletons and inflatable rings, number of inflatable rings, internal pressure of the inflatable rings, and internal pressure of envelope on mechanical performance of the envelope was investigated, and the evaluation index of inflatable ring parameters was proposed. Findings The research results indicate that compared with the traditional no-rigid airship without skeletons, the airship designed in this paper is significantly reduced in the maximum deformation of envelope, and is more uniform in the stress distribution of envelope. As the number of inflatable rings increases, the maximum deformation and maximum stress of envelope decrease, and the stress distribution of envelope is more uniform. The optimal recommended number of inflatable rings is 6. With the increase of the internal pressure of the inflatable rings, the maximum deformation of envelope decreases, and the maximum stress shows a trend that stabilizes first and then increases. The optimal recommended value of the internal pressure of the inflatable rings is about 200 kPa. As the internal pressure of the envelope increases, the contribution rate of internal skeletons to the improvement of mechanical properties decreases.

Stratospheric Verifying Airship Modeling and Analysis

Longitudinal Motion Analysis and Simulation for Lighter-Than-Air (LTA) Airship

Dynamic Modeling for Airship Equipped with Ballonets and Ballast

Analysis and Evaluation of Strengthening Effect of Inflatable Rings on Soft Stratospheric Airship

Modeling and analysis of moving-mass actuated stratospheric airship

Trim and Controller Design of Low Altitude Unmanned Airship

Real-Time Simulation Platform Design for Stratospheric Demonstrating Airship

Analysis of motion characteristics of the stratospheric airship in wind field

Command-Filtered Backstepping Control for A Multi-Vectored Thrust Stratospheric Airship

Thermal Simulation and Experiment for an Airship under Low Altitude Environment

Investigation of Airship Aeroelasticity Using Fluid-Structure Interaction*

Comparison Investigation for Architecture of Stratospheric Demonstration Airship

Modal Characteristics of a Scaling Stratospheric Airship in Still Air

Simulation of Moving-mass Control of Stratospheric Airship

Modeling and Simulation Analysis of Stratospheric Airship Envelope

Modeling and control of unmanned finless airship with robotic arms

Control of the Horizontal Position of a Stratospheric Airship During Ascent and Descent

Identification of Lateral Dynamics of Zy - 1 Airship

Control System Design of A Multivectored Thrust Stratospheric Airship

Initial Configuration and Nonlinear Mechanical Analysis of Stratospheric Nonrigid Airship Envelope

Longitudinal Motion Simulation of Stratospheric Airship under Dynamic Response of Moving-Mass Actuator