Abstract:Abstract The unsupported catalysts were obtained during hydrogenation by in situ high-temperature decomposition (above 300 °C) of water-soluble metal precursors (ammonium molybdate and nickel nitrate) in water-in-oil (W/O) emulsions stabilized by surfactant (SPAN-80) using elemental sulfur as sulfiding agent. These self-assembly Ni–Mo sulfide nanosized catalysts were tested in hydrogenation of aromatics under CO pressure in water-containing media for hydrogen generation through a water gas shift reaction (WGSR). The composition of the catalysts was determined by XRF and active sulfide phase was revealed by XRD, TEM and XPS techniques. The calculations based on TEM and XPS data showed that the catalysts are highly dispersed. The surfactant was found to affect both dispersion and metal distribution for Ni and Mo species, providing shorter slab length in terms of sulfide particle formation and stacking within high content of NiMoS phase. Catalytic evaluation in hydrogenation of aromatics was performed in a high-pressure batch reactor at T = 380–420 °С, p(CO) = 5 MPa with water content of 20 wt.% and CO/H 2 O molar ratio of 1.8 for 4–8 h. As shown experimentally with unsupported Ni–Mo sulfide catalysts, the activity of aromatic rings depends on the substituent therein and decreases as follows: anthracene>>1-methylnaphthalene≈2-methylnaphthalene>1,8-dimethylnaphthale-ne>>1,3-di-methylnaphthalene>2,6-dimethylnaphthalene≈2,3-dimethylnaphthalene>2-ethyl-naphthalene. The anthracene conversion reaches up to 97–100% for 4 h over the whole temperature range, while for 1MN and 2MN it doesn’t exceed 92 and 86% respectively even at 420 °С for 8 h. Among dimethyl-substituted aromatics the higher conversion of 45% was achieved for 1,8-dimethylnaphthalene with 100% selectivity to tetralines at 400 °С for 6 h. Similar to 1- and 2-methylnaphtalenes, the hydrogenation of asymmetric dimethyl-substituted substrate carries out through the unsubstituted aromatic ring indicating that steric factors influence on the sorption mechanism over active metal sites. The catalysts were found to be reused for at least six cycles when the hydrogenation is sulfur-assisted preventing metal oxide formation. It was established, that at the first 2–3 h known as the induction period, the oxide catalyst precursors formed slowly by metal salt decomposition, which reveals that it is the rate-determining step. The sulfidation is rather fast based on high catalytic activity data on 2MN conversion retaining at 93–95% upon recycling.

Hydrogenation of heavy aromatics in solvent oil over Ni2Mo3N/γ-Al2O3 catalysts

Sol-Gel Preparation, Characterization and Hydrogenation Property of Silica Supported Ni Catalyst

Role of the Solvent Evaporating Temperature on the NiMo/TiO2-Al2O3 Catalyst and the Hydrodesulfurization Performance for 4,6-Dimenthyldibenzothiophehe

Synthesis of Novel NiMo Catalysts Supported on Highly Ordered TiO2-Al2O3 Composites and Their Superior Catalytic Performance for 4,6-Dimethyldibenzothiophene Hydrodesulfurization

A Study on the Role of Ni Atoms in the HDN Activity of NiMoS2/Al2O3 Catalyst

Ni–Mo sulfide nanosized catalysts from water-soluble precursors for hydrogenation of aromatics under water gas shift conditions

Nickel molybdenum bimetallic nitrides as efficient catalysts for hydrodeoxygenation of methyl palmitate

Hydrogenation of coal tar on NiMoP/γ-Al2 O3 catalyst

Influence of Ni on the active phase and hydrodenitrogenation and hydrodesulfurization activities of MoS2 catalysts

Hydrogenation of Aromatics from Low Temperature Coal Tar over Novel Mesoporous NiMoC/Hβ Catalysts

Preparation of Highly Loaded and Active Ni/Al_2O_3 Catalysts for the Hydrogenation of Aromatic Rings

Selective Hydrogenation of Naphthalene over γ-Al2O3-Supported NiCu and NiZn Bimetal Catalysts

HYDROGENATION PROPERTIES OF Mo-Ni-P CATALYST ON MCM-41 SUPPORTED

Hydrogen Separation from Gas Mixtures by Its Chemical Storage via Hydrogenation of Aromatic Compounds over Dispersed Ni–Mo–Sulfide Catalysts

SELECTIVITY OF HYDRO-PROCESSES FOR POLY-CYCLIC AROMATICS HYDROGENATION SATURATION ON Ni-Mo-W/Al;O; AND Co-Mo/Al;O; CATALYSTS

Fabrication of Well-Structured NiMo Hydrodesulfurization Catalysts Using Electropositive Mo-based Nanoparticles

Synthesis of mesoporous TiO2-Al2O3 composites supported NiW hydrotreating catalysts and their superior catalytic performance for heavy oil hydrodenitrogenation

Electronic Tuning of Ni by Mo Species for Highly Efficient Hydroisomerization of N-Alkanes Comparable to Pt-Based Catalysts

Synthesis of Ni/Mo/N Catalyst and Its Application in Benzene Hydrogenation in the Presence of Thiophene

Hydrogen or synthesis gas production via the partial oxidation of methane over supported nickel–cobalt catalysts

A Highly Active NiMoAl Catalyst Prepared by a Solvothermal Method for the Hydrogenation of Methyl Acrylate