Abstract:The actions exerted by yawed wind on the crossarm substantially differ from those on the tower body due to the presence of the angle between the crossarm's cross-section and the incoming flow, and this phenomenon deserves a better understanding. Focusing on the tubular crossarms with round-section members, this paper aims to determine insights into wind actions, as affected by various factors, such as the tower type, the mean width to mean height ratio, the solidity ratio, and the wind incidence angle, and thereby derive the wind loads for design. Accordingly, a succession of wind tunnel tests was conducted by using quadrilateral and triangular crossarm models with various solidity ratios and mean width to mean height ratios. The method of direct force measurement (DFM) is employed for the high frequency force balance (HFFB) test to attain the transverse and longitudinal forces on the crossarm simultaneously. It was found that the wind load coefficients increase with increases of the mean width to mean height ratio and decreases of the solidity ratio. Moreover, in the case of the incoming flow perpendicular to the crossarm face, it is concluded that compared to the quadrilateral crossarm, the triangular crossarm possesses a relatively smaller drag coefficient, provided a moderate mean width to mean height ratio of 1.19. Furthermore, an analysis of the experimental results shows that the skewed wind load factor specified in the relevant codes would overestimate the effects of the wind incidence angle and the variations in mean width to mean height ratio, which is evident in the tests but not considered in the codes. It is worth noting that the experimental results show that the crosswind force is pronounced, which is usually ignored in the skewed wind load factor-based approach. Comparatively, using wind load distribution factors seems to be more rational. Thus, the corresponding estimating equations are proposed for the wind load-distribution factors of the crossarms, which agree well with the experimental results. The developed equations would greatly facilitate the determination of wind loads on tubular crossarms.

Calculation Methods and Effective Distributions of Equivalent Alongwind Loads on Bridges

Simplified Calculation of Equivalent Wind Loads of High Pier Continuous Rigid Frame Bridge in Double Cantilever State

The Numerical Simulation for the Wind Fields and Wind Loads Around Spatial Structures

Methods of calculating wind loads on long-span girder bridges with tall piers and comparison of values

Practical formulae of wind-induced vibration factor for double-layer cylindrical and spherical grid structures

A SIMPLE METHOD TO CALCULATE THE EQUIVALENT STATIC WIND LOAD ON LOW-RISE BUILDINGS

Analysis and Comparison on Wind Load of Long Span Girder Bridges with High Pier

Development of joint probability distribution of wind speed and direction using long-term monitoring data

Coupled wind-induced responses and equivalent static wind loads on long-span roof structures with the consistent load–response–correlation method

Calculation method for equivalent static wind loads and wind load adjustment coefficients for transmission lines

Wind Load Assessment with the JPDF of Wind Speed and Direction Based on SHM Data

Calculating Method and Experimental Research on Lateral Load Distribution of Transversely Strengthened Hollow Slab Bridge

Equivalent static wind load based on displacement mode and load combination for high‐rise buildings

Along-Wind Response And Equivalent Static Wind Load Of Transmission Tower

Extreme load effects on a bridge tower-basement system under the joint action of wind and wave based on the EC method

An improved Chinese load code method for the evaluation of wind‐induced base shear force on base‐isolated buildings

Equivalent static wind loads on canopies of regular railway stations

Equivalent static wind loads on low-rise buildings based on full-scale pressure measurements

Research on Equivalent Static Load of High-Rise/Towering Structures Based on Wind-Induced Responses

Calculation of Wind-Induced Responses and Equivalent Static Wind Loads of High-Rise Buildings Based on Wind Tunnel Tests

Experimental Study of Wind Loads on Tubular Crossarms of Transmission Towers