Thermal performance of phase change materials embedded in functional gradient triply periodic minimal surface structures
Xiaokai Zhang,Hongyang Li,Hongsheng Dong,Yi Zhang,Mingrui Sun,Yongchen Song
DOI: https://doi.org/10.1016/j.est.2024.113636
IF: 9.4
2024-09-08
Journal of Energy Storage
Abstract:Triply periodic minimal surface (TPMS) topology based on functional porosity gradient enhances the thermal storage performance of PCMs. However, there is a lack of quantitative studies on the relationship between increased heat transfer performance and porosity gradient size. In this work, four porosity gradient models of 17.5 %, 15 %, 10 % and 5 % were established, and three typical TPMS structures of Gyroid, I-WP and Primitive were considered. The thermal performances of gradient TPMS-based MFPCMs are numerically studied. The results show that the initial thermal conduction improves with increasing porosity gradient size compared to uniform structures, but later-stage thermal conduction is reduced. By comparing models with different porosity gradient sizes, it was concluded that the 15 % graded Primitive, 15 % graded I-WP, and 10 % graded Gyroid structures show the most significant benefits for thermal conduction, with complete melting times under pure conduction reduced by 3.6 %, 6.7 %, and 4.7 %, respectively. Additionally, convective heat transfer contributions vary across TPMS types, as the porosity gradient size increases, the contribution in Gyroid and I-WP structures first increases and then decreases, while it consistently weakens in the Primitive structure. Coupled with thermal conduction and convective heat transfer, all gradient configurations accelerate the melting (1.9–3.8 % for Primitive, 4.8–8.1 % for I-WP, and 3.3–6.4 % for Gyroid structures). The complete melting time of TPMS-based MFPCMs decreases initially and then increases with the increasing porosity gradient size, showing no strict positive relationship. Optimal configurations were identified as 10 % graded Primitive(131.1 s), 15 % graded I-WP structures(141.9 s), and 15 % graded Gyroid(153.7 s). These results prove the existence of the optimal porosity gradient size, which offer valuable guidance for the design and optimization of advanced thermal energy storage devices.
energy & fuels