Abstract:Cooling load calculation can significantly affect the first cost, energy consumption, and performance of air-conditioning systems. Current peak cooling load calculation theories and methods are developed based on all-air systems, which remove the room heat gains through purely convective heat transfer. Studies found that they are not suitable for radiant systems that remove room heat gains through both radiation and convection, especially for the integrated operation of radiant terminal and dedicated outdoor air system (DOAS). This study proposed a revised radiant time series method (RTSM) to calculate the cooling load for radiant systems. The method assumes the heat transfer rate of the radiant terminal as a negative “heat gain” and uses radiant time series factors to calculate the cooling load for DOAS. From the results of an example room, we find that the proposed RTSM has good accuracy compared to the heat balance method (HBM), while it slightly underestimates/overestimates the cooling load for radiant terminal/DOAS. Besides, a parametric simulation with 34,992 cases considering nine impact factors was performed. We find that compared to HBM, the relative errors of the peak cooling loads for the majority of the cases are within ± 10%, and the peak load occurring time differences are very minor, which are within the accuracy range of engineering applications. In summary, the revised RTSM was developed to offer a rigorous cooling load calculation approach for radiant systems, yet does not require complicated iterative calculations. Moreover, though originated from HBM, it has additional advantage of quantifying the cooling load converted from different heat gains separately, which is preferred in engineering applications.

Calculating Exchange Factors of the G Style Radiant Cooler by the Monte Carlo Method

Research On Accelerating The Monte Carlo Method In Radiant Space Cooler Calculation

ACCELERATLNG THE MONTE CARLO METHOD IN CALCULATION OF COUPLING FACTORS OF SPACE RADIANT COOLERS

Radiation Symmetry Test and Uncertainty Analysis of Monte Carlo Method Based on Radiative Exchange Factor

Determination of Simulation Parameters in Monte Carlo Ray Tracing for Radiative Flux Density Distribution Simulation

Monte Carlo Method for Calculating Particle Radiation Detector Correction Factors

Development of a generalized radiation calculation system

Monte Carlo Source Convergence Diagnosis Method and Thermal-Physics Coupling Method Based on Functional Expansion Tallies

Influence factors and calculation method of radiant panel cooling capacity

Efficiency Calculation of the Large Container Inspecting System Using Monte Carlo Method

Calculation techniques with the Monte Carlo method in stray radiation evaluation

A Calculational Method for Environment Heat Flux on Spacecraft with Complicated Structure

A revised radiant time series method (RTSM) to calculate the cooling load for pipe-embedded radiant systems

Numerical Evaluation on the Thermal Performance of the Solar External Cylinder Receiver Using Monte Carlo Ray-Tracing Algorithm

How to rapidly and accurately evaluate the cooling performance of radiative cooling materials?

Combining domain decomposition method with monte carlo method to determine the temperature profile and infrared radiance of tank

Numerical Computation of External Heat Flux of Low Earth Orbit Spacecraft by RUD

Monte Carlo Simulation of Transfer Coefficient of Γ-Ray Density Meter

Evaluation of Monte Carlo Method for Modeling Glazing Behavior During Radiant Exposure

Effect of surface radiation on the transient cooling of heat sources under forced convection - A numerical study

The Calculation of Thermal Conductivities by Three Dimensional Direct Simulation Monte Carlo Method.