Dielectric Properties in Low Density Polyethylene Modified by Metallocene Catalyzed Polyethylene
Chaoyi WU,Xia WANG,Huaqin HE,Demin TU
DOI: https://doi.org/10.3969/j.issn.1003-6520.2006.07.009
2006-01-01
Abstract:Space charge effect is undesirable for HV and EHV plastic power cable. Up to now, the insulating materials of most DC power cables are traditional modified polyethylene (PE) in order to have superior dielectric properties such as space charge accumulation, volume resistivity, breakdown strength and so on. The common modification can be achieved by various methods such as the uses of additives, blending, grafting and copolymerization. In general, blending is a widely used technique to improve dielectric properties of PE. Based on blending technique, metallocene catalyzed polyethylene (MPE) is blended into low-density polyethylene (LDPE) in this paper. Then the space charge profile in the blends is measured by pulsed electro-acoustic (PEA) method. And at the same time, the volume resistivity of blends is measured by micro-current detector. In addition, the AC breakdown strength of blends is measured by step voltage. It is shown by test results that LDPE blending with 1% of MPE could effectively decrease the space charge effect, increase the AC breakdown strength by 7.9% and slightly reduce the volume resisitivity. The test results of the resistivity are consistent with that of space charges. It is validated that the blending by proper amount of MPE could decrease the deep traps, increase the shallow traps and the charge mobility in LDPE. Polyethylene is a typical semicrystalline including crystal phase and amorphous phase. The electrical breakdown path advances along the boundaries of spherulites, or trans-crystal, or lamella of LDPE, which means that electrical breakdown path go through amorphous area in polymers. So the increase of AC breakdown strength may be related with the micro-structure and crystalline morphology of LDPE, such as the increase of crystal phase and the decrease of amorphous, or the increase of crystallinity can improve the breakdown strength. At the end of this paper, the relation among material structure, charge trap and dielectric properties in the blends is analyzed and discussed.