Abstract:In structural deformation monitoring, traditional methods are mainly based on the deformation data measured at several individual points. As a result, only the discrete deformation, not the overall one, can be obtained, which hinders the researcher from a better and all-round understanding on the structural behavior. At the same time, the surrounding area around the measuring structure is usually complicated, which notably escalates the difficulty in accessing the deformation data. In dealing with the said issues, a digital image-based method is proposed for the overall structural deformation monitoring, utilizing the image perspective transformation and edge detection. Due to the limitation on camera sites, the lens is usually not orthogonal to the measuring structure. As a result, the obtained image cannot be used to extract the deformation data directly. Thus, the perspective transformation algorithm is used to obtain the orthogonal projection image of the test beam under the condition of inclined photography, which enables the direct extraction of deformation data from the original image. Meanwhile, edge detection operators are used to detect the edge of structure’s orthogonal projection image, to further characterize the key feature of structural deformation. Using the operator, the complete deformation data of structural edge are obtained by locating and calibrating the edge pixels. Based on the above, a series of load tests has been carried out using a steel–concrete composite beam to validate the proposed method, with the implementation of traditional dial deformation gauges. It has been found that the extracted edge lines have an obvious sawtooth effect due to the illumination environment. The sawtooth effect makes the extracted edge lines slightly fluctuate around the actual contour of the structure. On this end, the fitting method is applied to minimize the fluctuation and obtain the linear approximation of the actual deflection curve. The deformation data obtained by the proposed method have been compared with the one measured by the dial meters, indicating that the measurement error of the proposed method is less than 5%. However, since the overall deformation data are continuously measured by the proposed method, it can better reflect the overall deformation of the structure, and moreover the structural health state, when compared with the traditional “point” measurements.

Application of digital photogrammetric technique for deformation measuring in structural experiment

Applications of the digital photogrammetry in the studies on shear behavior of concrete beams

Image-Based Structural Dynamic Displacement Measurement Using Different Multi-Object Tracking Algorithms

Measurement of deformed surface and key data processing based on reverse engineering

Identification of Structural Dynamic Characteristics Based on Machine Vision Technology

An Overall Deformation Monitoring Method of Structure Based on Tracking Deformation Contour

Experimental Study on Measuring and Tracking Structural Displacement Based on Surveillance Video Image Analysis

A Case Study on the Application of 3D Scanning Technology in Deformation Monitoring of Slope Stabilization Structure

Vision-based Structural Displacement Measurement: System Performance Evaluation and Influence Factor Analysis

Three-dimensional digital image correlation system for deformation measurement in experimental mechanics

Multi-Point Displacement Monitoring of Bridges Using A Vision-Based Approach

Full-field Measurement of Deformation and Vibration using Digital Image Correlation

A Vision-Based System for Dynamic Displacement Measurement of Long-Span Bridges: Algorithm and Verification

Dynamic Inspection Technology of Tunnel Deformation Based on Onboard LIDAR

Methods and research for deformation monitoring of earth and rock dams based on close-range photogrammetry

Measurement of Displacement for Open Pit to Underground Mining Transition Using Digital Photogrammetry

Non-contact measurement of structural dynamic displacement based on improved edge detection and video interpolation

A New Method Based on Photogrammetry for Hull'S Deformation Measurement and Its Accuracy Analysis

Full-field Deformation Measurement of Structural Nodes Based on Panoramic Camera and Deep Learning-Based Tracking Method

Photogrammetric Techniques in Civil Engineering Material Testing and Structure Monitoring

Developing an Optical Image-Based Method for Bridge Deformation Measurement Considering Camera Motion