Abstract:Space nuclear power systems should be strictly limited in mass and size. Lack of detailed designs, mass estimation in the general design phase usually relies on simple and empirical models that leave too much design margin from the limits. Accurate mass estimation of space nuclear power systems is key to minimize the design margin and maximize the system performance in the general design phase. In this paper, new mass estimation models are proposed for the main components of space nuclear power systems, including nuclear reactor, shield, turbine, compressor, heat exchanger, and thermal radiator. The mass estimation models are more accurate by incorporating principles of nuclear physics, thermal hydraulics, and structural mechanics to the component designs. Combined with thermodynamic models and genetic algorithm, the MEGREZ code is developed to optimize the system performance by setting efficiency and mass as dual objectives. The code verification results indicate that the deviations between and the Jupiter Icy Moons Orbiter project parameters and the code calculated values are only 0.4% for system efficiency and 2.1% for system mass. The optimization for the Jupiter Icy Moons Orbiter project shows that the optimal molecular weight of helium-xenon mixture is the minimum value for single-stage turbomachinery limits. Additionally, the impacts of potential technological degradation, such as increased heat exchanger thermal resistances, higher frictional factors, and decreased turbomachinery efficiency, on system performances are discussed. The results show that turbomachinery efficiency presents the strongest influence on the system-specific mass; a 0.04 reduction in the polytropic efficiency of the compressor or turbine results in more than a 10% increase in system-specific mass.

THE GLOBAL OPTIMIZATION STUDY OF SPACE SOLAR DYNAMIC POWER SYSTEM

Optimal Analysis of a Space Solar Dynamic Power System

Design and on-orbit verification of ZDPS-1A power system

Study on Simulation of On-Orbit Energy Balance of Pico-Satellite

Design and Simulation of Pica-Satellite Power System

Study on Optimal Parameter Design for Space Nuclear Reactor

DYNAMIC SIMULATION OF SPACE SOLAR-DYNAMIC POWER SYSTEM

Global Mass Optimization of Spacecraft Thermal Control Loop

A synchronous placement and size-based multi-objective optimization method for heat dissipation design on antenna module of space solar power satellite

Conditional Extremum Optimization Analyses and Calculation of the Active Thermal Control System Mass of Manned Spacecraft

An Optimal Scheduling of the Heliostat Field in A Solar Tower Power Plant

Efficiency and Mass Optimization for Space Nuclear Power Systems with Closed Brayton Cycle Loops

An Optimization Method of Separation Parameters for Pico-Satellite by Minimizing External Moment

Mass Optimization of SPE Oxygen Generation System in Manned Spacecraft

Layout Optimization of Spacecraft-Based Solar Array under Partially Shaded Conditions

Global optimization of solar sail gravity assist and solar photonic assist trajectory for interstellar mission

Study of Optimal Design for Stand-Alone Wind/solar Hybrid Power Systems

Optimal Configuration of Wind–Solar–Thermal-Storage Power Energy Based on Dynamic Inertia Weight Chaotic Particle Swarm

Design and Research of High Voltage Power Conversion System for Space Solar Power Station

An Approach to Optimizing the Initial Orbital Elements of Spacecraft Base on TOPSIS Method

Optimization technique for energy mass characteristics of the EPS of a geostationary spacecraft