Abstract:The development of efficient sample introduction and pretreatment systems for microfluidic chip-based analytical systems is important for their application to real-life samples. In this work, world-to-chip interfacing was achieved by a novel flow-through sampling reservoir featuring a guided overflow design. The flow-through reservoir was fabricated on a 30 x 60 x 3 mm planar glass chip of crossed-channel design used for capillary electrophoresis separations. The 20-microL sample reservoir was produced from a section of plastic pipet tip and fixed at one end of the sampling channel. Sample change was performed by pumping 80-microL samples sandwiched between air segments at approximately 0.48 mL/min flow rate through the flow-through reservoir, introduced from an access hole on the bottom side of the chip. A filter paper collar wrapped tightly around the reservoir guided the overflowing sample solution into a plastic trough surrounding the reservoir and then to waste. The performance of the system was demonstrated in the separation and determination of FITC-labeled arginine, glycine, phenylalanine, and glutamic acid with LIF detection, by continuously introducing a train of different samples through the system without electrical interruption. Employing a separation channel of 4 cm (2-cm effective separation length) and 1.4-kV separation voltage, maximum throughputs of 80/h were achieved with <4.1% carryover and precisions ranging from 1.5% for arginine to 2.6% RSD (n = 11) for glycine. The sampling system was tested in the continuous monitoring of the derivatizing process of amino acids by FITC over a period of 4 h, involving 166 analytical cycles. An outstanding overall precision of 4.8% RSD (n = 166) was achieved for the fluorescein internal standard.

A Programmed Power For Capillary Electrophoresis On A Chip

Microfabrication of Integrated Capillary Electrophoresis Chips and On-chip Sample Injection and Separation

A Pressure-Driven Capillary Electrophoretic System with Injection Valve Sampling.

An Automated Electrokinetic Continuous Sample Introduction System for Microfluidic Chip-Based Capillary Electrophoresis

Development Of Integrated Capillary Electrophoresis Chips Technology

A high-performance polycarbonate electrophoresis microchip with integrated three-electrode system for end-channel amperometric detection.

Microfluidic Analysis System Based On Capillary Electrophoresis Chip

A Chip-based Capillary Electrophoresis System for High-efficiency Bioanalysis

Development of integrated capillary electrophoresis chips]

Gel Electrophoresis Chip Using Joule Heat Self-Dissipation, Short Run Time, and Online Dynamic Imaging

Study of Capillary Electrophoresis Chip with Conductivity Detection

A High-Throughput Continuous Sample Introduction Interface for Microfluidic Chip-Based Capillary Electrophoresis Systems.

A Novel Integrated Capillary Electrophoresis Chip with a Self-Rinsing Micropump

New analytical portable instrument for microchip electrophoresis with electrochemical detection

Miniaturized Two-Dimensional Capillary Electrophoresis on a Microchip for Analysis of the Tryptic Digest of Proteins.

Design and Operation of a Portable Scanner for High Performance Microchip Capillary Array Electrophoresis.

A Micro Electrophoresis System Based On A Short Capillary Combined With Hydrostatic Pressure Driven Injection And Assisted Separation

Two-dimensional electrophoresis on microfluidic chip

Fast and simple sample introduction for capillary electrophoresis microsystems.

Efficient and High-Throughput Electroporation Chips

Two Benches PDMS Free Flow Electrophoresis Chip