Abstract:This work examined liquefaction of polypropylene into liquid products in the presence of ethanol with particular attention to the effect of temperature (325-400 & nbsp;C), residence time (1-6 h) and solvent/feedstock mass ratio (1/ 1-4/1) on the overall product distribution, and composition of the oil products. The oil products obtained under the optimal reaction condition contained mainly alkanes, alkenes, alcohols and aromatics, which accounted for 42.41%, 22.81%, 3.51%, 1.05%, respectively. Increasing temperature and retention time enhanced aromatization reaction leading to increased yields of aromatic hydrocarbons. The higher heating value of the oil product was 45.72 MJ/Kg, which is comparable to the higher heating value (HHV) of gasoline. Volatility analysis shows that 50-85 wt% of the oil composition had similar boiling point range as gasoline (35-185 C). These characterization results suggest that the oil could be used as a raw material for gasoline blendstock or chemicals. The interaction of three reaction parameters on the oil formation was further evaluated by the response surface method. Through the Box-Behnken design, the R-2, F-value and p-value of analysis of variance were 0.9917, 93.20, and < 0.0001, respectively, showed that the model fitted well with actual experimental value. It is suggested that the reaction temperature affect the oil yield more significantly, compared to other two parameters. The response surface analysis showed that under the temperature of 376.7 C, residence time 3.8 h and solvent/feedstock mass ratio of 1/1, oil yield of 98.32 wt% can be achieved without adding catalyst or hydrogen. This predication was also verified by experiment.

Pilot Plant Test of Preparing Cumene by Liquid-Phase Alkylation

Liquid Phase Catalytic Oxidation of Cumene

Preparation of Bimetallic CuZn@mSiO2 Yolk‐Shell Catalyst for the Selective Oxidation of Cumene to Acetophenone

Alkylation of Benzene with 2-Chloropropane to Prepare Cumene with Chloroaluminate Ionic Liquids As Catalyst

Study on Catalyst Packing Structure in Catalytic Distillation Process for Cumene Synthesis

Preparation of PtCl62-Intercalated Mg/Al-hydrotalcite Catalyst and Its Catalytic Activities for the Hydrosilylation of Olefins

A new internal structure used in catalytic distillation reactor - II. Synthesis of cumene

EFFECT OF REACTION CONDITIONS ON DEACTIVATION OF ZEOLITE β FOR BENZENE PROPYLATION

Cumene autooxidation to cumene hydroperoxide based on a gas-liquid microdispersion strategy

Influence of temperature, residence time, and solvent/feedstock mass ratio on overall product distribution and oil products quality in ethanol liquefaction of 230 polypropylene impact copolymer

Nature and Location of Deposit on Beta Zeolite Catalyst for Isopropylation of Benzene with Propene to Cumene

Effect of Methanol on Catalytic Performance of Hy Zeolite for Desulfurization of Fcc Gasoline by Alkylation

Study on the Alkylation of Benzene with Propylene over Hβ Zeolite

Hydrocracking of Bio-Alkanes over Pt/Al-MCM-41 Mesoporous Molecular Sieves for Bio-Jet Fuel Production

Simulation of Catalytic Distillation Process for Cumene Synthesis

Controllable alkylation of benzene with mixed olefins for producing C8-C15 aromatics in jet fuel

Alkylation of Benzene and Dichloromethane to Diphenylmethane with Acidic Ionic Liquids

An Insight into Effect of Methanol on Catalytic Behavior of Amberlyst 35 Resins for Alkylation Desulfurization of Fluid Catalytic Cracking Gasoline

Characterization of the deposit on zeolite β catalyzed benzene propylation

Preparation of PtCl_6~(2-) Intercalated Mg/Al-hydrotalcite Catalyst and Its Catalytic Activities for the Hydrosilylation of Olefins

Non-equilibrium Stage Model of Catalytic Distillation for Cumene Synthesis Using Low Concentration Propylene and Benzene