Abstract:A two-way coupled Computational Fluid Dynamics (CFD) and Discrete Element Method (DEM) calculation was performed to numerically investigate the gas and powder flow characteristics within a packed bed. The analysis and discussion focused on the effects of gas phase velocity, particle shape, and size on the flow behavior of the powders. The results revealed that the average absolute velocity of the powder increased with an increase in the inlet gas flow rate. Conversely, the average dimensionless velocity exhibited the opposite trend. Particle shape significantly impacted the flowability of the powders. A critical value of sphericity equal to 0.96 was observed. For powders with sphericity less than 0.96, the average velocity fluctuated around a progressively decreasing value over time, and the powders tended to accumulate in the inlet region. In contrast, powders with a sphericity greater than 0.96 exhibited average velocities fluctuating around a constant value throughout the simulation. Additionally, a smaller number of these particles remained within the fluid domain, indicating a higher flow rate through the packed bed and ultimately exiting the fluid domain. Regarding the influence of particle size, the flowability reached a minimum value at a radius of 0.14 mm, with the average powder velocity mirroring this trend. Powders with a radius exceeding 0.14 mm demonstrated increasing flowability and average velocity. The observed impact on flowability was likely due to a combination of mechanisms. The findings presented in this paper offer valuable insights into the dynamics of powders within a packed bed. This knowledge can be instrumental in the design and analysis of packed bed reactors.

Gas Flow and Heat Transfer in a Moving Packed Bed of Particle

GAS FLOW AND HEAT TRANSFER IN MOVING PARTICULATE BED

Heat Penetration into Feed Stream Within Horizontal Pipe

Heat Transfer of Batch Simulating Continuous Fluidized Bed with Wet Particles

Characterization of Flow Pattern of Cohesive Particles in Gas-Solid Fluidized Bed Via Axial Distribution of Particle Motions

Particle Fluidization Characteristics and Transition in a Hot Gas-Solid Fluidized Bed with Liquid Injection

Heat Transfer and Gas Flow through Feed Stream within Horizontal Pipe

Modeling of Hot Gas Flow Through a Feed Stream Within a Horizontal Pipe

Numerical Study on Heat Transfer Performance in Packed Bed

Particle-scale Simulation of Fluidized Bed with Immersed Tubes

Heat Transfer Characteristics in the Dense Phase Region of a Pressurized Fluidized Bed

Numerical investigation of transient gas–solid heat transfer in a packed bed: Impact of intra-particle thermal diffusion

Gas–powder Flow and Powder Accumulation in a Packed Bed

Gas Pulsation Effect on Flow Behaviors and Heat Transfer in a Tapered Fluidized Bed

An analysis of compressible flows in a packed bed with gas–solid reactions

Numerical Investigation of the Air-Particles Heat Transfer Characteristics of Moving Bed - Effect of Particle Size Distribution

Simulation of Turbulent Flow in A Packed Bed

Particle-Fluid Heat Transfer In A Circulating Fluidized Bed

Gas and Powder Flow Characteristics of Packed Bed: A Two-way Coupled CFD-DEM Study

Gas–solid Flow and Heat Transfer in Fluidized Beds with Tubes: Effects of Material Properties and Tube Array Settings

A unified approach to the convective heat transfer in packed beds