Abstract:In prefabricated buildings, lateral-distortional buckling (LDB) of I-section steel beams is a common failure mode that has garnered considerable attention. However, existing studies and design methods for lateral-distortional buckling primarily focus on members subjected to in-plane flexure and do not take into account the influence of shear forces. In this paper, a study on the elastic lateral-distortional buckling behavior of I-section steel beams under in-plane shear loads was conducted. Firstly, refined finite element (FE) models of beam webs under shear loads were established and validated against theoretical formulas for different boundary conditions. Subsequently, by combining with analytical solutions and numerical results, an accurate buckling load formula for the beam web with a free bottom edge was obtained, which can be used for further study. Based on the parametric analysis results, a formula was obtained to determine the critical flexural stiffness ratio of flange to web. When the flexural stiffness ratio exceeds the critical value, the lateral-distortional buckling of I-section steel beams can be effectively avoided. Finally, a formula that incorporates both the critical flexural stiffness ratio and the span to height ratio was proposed to calculate the elastic critical lateral-distortional buckling loads of I-section steel beams solely under in-plane shear loads.

LATERAL BUCKLING ANALYSIS OF THIN-WALLED MEMBERS WITH IRREGULAR I-SHAPED OR L-SH APED CROSS SECTION

Buckling Analysis of Thin-Walled Members Using the Spline Finite Member Element Method

A Controversy and Its Settlement in the Calculation of Buckling Moments of Thin-walled Beams with Monosymmetrical I-sections under Distributed Loads

Finite Element Modelling of Thin-Walled Members in Overall Stability Analysis

Lateral Buckling of Web-Tapered I-beams: A New Theory

A New Derivation of the Buckling Theory of Thin-Walled Beams

LATERAL BUCKLING ANALYSIS OF THIN-WALLED CURVED BEAMS

ADAPTIVE FINITE ELEMENT PROCEDURE FOR PIPE SECTION LATTICED SHELL STRUCTURES

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

A unified analysis for distortional and lateral buckling of C-purlins in flexure

Stability analysis of thin-walled members by degenerated three-dimensional beam element method

A General Theory for the Flexural-Torsional Buckling of Thin-Walled Members I: Energy Method

Elastic flexural-torsional buckling of thin-walled cantilevers

OUT-OF-PLANE STABILITY OF MONOSYMMETRIC WEB-TAPERED I-BEAMS

An Analysis of Current Stability Theories for Thin-Walled Members

Elastic Buckling of Inter-Braced Parallel Beam Systems

LOCAL AND DISTORTIONAL BUCKLING OF COLD-FORMED C AND Z-SECTION MEMBERS UNDER BENDING

Elastic Local Buckling and Width-to-Thickness Limits of I-Beams Incorporating Flange–Web Interactions

ELASTIC FLEXURAL-TORSIONAL BUCKLING OF C-PURLIN AND Z-PURLIN

Stability analysis method for lattice shells accounting for buckling of members

Elastic Flexural-Torsional Buckling of Doubly Symmetric Web-Tapered I-Beams