Abstract:In this paper, a high-static-low-dynamic stiffness (HSLDS) vibration isolator with a novel parabolic-cam-roller negative stiffness mechanism is proposed to study the effectiveness of negative stiffness on asymmetric spring supporting structures. Based on the physical model, the intrinsic geometrical nonlinearity of the isolator is analyzed and the differential equation of motion is derived by the generalized Lagrange's equation. Here, the multi-term incremental harmonic balance method (MT-IHBM) is employed and extended to capture both primary and subharmonic resonances in nonlinear response. By means of arc length increment, the adaptability and reliability of this method are enhanced under strong nonlinear vibration. Vibration transmissibility and frequency response relationships of various frequency components are demonstrated in order to better explain the properties of asymmetry vibration. The analysis results indicate that the performance of the isolation system is affected by different parametric excitation. Under some parameters, the introduction of negative stiffness will cause obvious 1/2 subharmonic resonance. The existence of the bias term in response makes the peak and frequency of resonances shift vertically and horizontally, respectively. Due to the asymmetry, the proposed HSLDS isolator does not present quasi-zero stiffness at the static equilibrium position, but it has superior ability to suppress vibration. Meanwhile, comparisons show that adding negative stiffness mechanism can still significantly improve the vibration isolation performance when a supporting structure has the characteristic of asymmetric stiffness. (C) 2019 Elsevier Ltd. All rights reserved.

On Double Frequency Vibration of a Generator-Bearing System with Asymmetrical Stiffness

Nonlinear Dynamic Analysis of an Unsymmetrical Generator-Bearing System

Analysis of Flexural and Torsional Vibration for Turbogenerator Shafts on Power Impact

Effect of Negative Stiffness Mechanism in a Vibration Isolator with Asymmetric and High-Static-low-dynamic Stiffness

Signal Analysis on Flexural and Torsional Vibration of Generator Shafts Impacted by Subsynchronous Resonance

Dynamic modeling and vibration response analysis of high speed motorized spindle

Magneto-Mechanical Coupling Analysis Of Asynchronous Motor Considering Stator Vibration

The coupled bending and torsional vibrations of the high-speed geared rotor-bearing system

Transient analysis of multi-field coupling on suspension inertial vibration machine

Influence of simultaneous time-varying bearing and tooth mesh stiffness fluctuations on spur gear pair vibration

Nonlinear vibration and stability analysis of a dual-disk rotor-bearing system under multiple frequency excitations

Nonlinear Vibration Analysis of the Coupled Gear-Rotor-Bearing Transmission System for a New Energy Vehicle

Dynamic Analysis of an Unbalanced Rotor-Water Pump-Bearing System Considering Varying Compliance Effect and Localized Defects on Bearing Races

Nonlinear Dynamic Simulation Of Coupled Lateral-Torsional Vibrations Of A Gear Transmission System

Vibration of a Misaligned Rotor System with Asymmetric Shaft Stiffness

Response characteristics of a rotor-bearing system with double-frequency time-varying bearing stiffness

Torsional and lateral vibration analysis of wind turbine generator bearing outer ring fault considering unbalanced magnetic pull

Non-Linear Dynamics Of Gear Pair With Combined Internal And External Periodic Excitations

Dynamic Model and Numerical Simulation of Multi-stage gear-rotor-bearing System

Coupled vibration modeling and dynamic characteristics of noncircular face gear drive system with time-varying instantaneous center excitation

Forced oscillations with time-varying mesh stiffness and backlash in gear systems