Abstract:When analyzing the dynamic characteristics of marine cables, the static equilibrium state must first be calculated; a dynamic analysis can then be carried out based on the static equilibrium. Since the calculation of the static equilibrium is the basis of dynamic calculation, different methods for the calculation of the static equilibrium will have important impacts on the dynamic response characteristics of cables, which result in cables having different dynamic characteristics. This paper summarizes the research progress in the effects of different methods for the calculation of the static equilibrium on the dynamic response of marine cables during the releasing process, and current methods for their static calculation are more comprehensively developed as well as being more accurate. To study the influence of different static equilibrium calculation methods, with the reference of some specific parameters of a mooring cable, combined with specific sea conditions, through the necessary simplification of the cable releasing process, based on the lumped mass method, mooring cables are discretized into the lumped mass model, and dynamic analysis models of the releasing process of mooring cables under three methods for the calculation of the static equilibriums (the fast static equilibrium calculation method, the analytic catenary calculation method, and the catenary calculation method) are established. The dynamic characteristics of the spatial configurations of mooring cables based on different static equilibrium calculation methods are obtained through time domain coupling analyses. It was found that if the static equilibrium of a cable is calculated, taking into account gravity, buoyancy, wave current resistance, inertia forces, and the axial stiffness of a cable, then the characteristics of a cable during dynamic descent are closest to that of a real situation. The calculation results have a certain guiding significance for specific engineering practices.

The calculation of cable-lengths used in closed loop control on the movement of the cable-suspended feed cabin structure

Dynamic Analysis of Towed Cable with Variable Length During Turning Maneuvers

Determination of a Monitoring Scheme for Controlling Construction Errors of a Cable-strut Tensile Structure

Influence of Different Static Equilibrium Calculation Methods on the Dynamic Response of Marine Cables during the Releasing Process: Review and a Case Study

Inverse analysis method for calculating cable tension based on controlling the initial length of cables

METHOD OF CABLE FORCE CONTROL DURING ACCUMULATIVE SLIDING CONSTRUCTION FOR PRETENSIONED RETICULATED STRUCTURES

NONLINEAR VIBRATION OF STEEL AND CFRP CABLES OF LONG SPAN CABLE-STAYED BRIDGE UNDER VEHICULAR LOADS

Application of Wireless Cable Force Measurement System of Cable Structures

A Calculating Method of the Load-relieving System

Experimental Analysis of Rod-Cable Deployable Mast System

Cable force adjustment and post-adjusting nonlinear analysis of a cable-stayed bridge based on ANSYS

Length Amending of Straddle Suspender Cable in Main Cable Clip

Stability Analysis of a Semi-active Controlled Stay Cable

Dynamics modeling and performance verification of the mechanical flight control system on transport airplane

Analysis of Cable under Dynamic Contact and Large Deformation

Optimization of Cable Tensions of a Cable-Driven Parallel Manipulator for a Large Radio Telescope

Three-dimensional dynamic modeling and analysis of moving elevator traveling cables

Dynamic Modeling And Analysis Of Three-Dimensional Slack Cables With Application To Elevator Traveling Cables

A general framework for sliding cable analysis with elastic catenary equation

Motion Simulation Analysis Of The Cable-Body Of The Deep Underwater Towed System

Analysis and design of 3T cable-driven parallel manipulator for the feedback’s orientation of the large radio telescope