Abstract:Excavation behaviours not only destroy the balance of original stress in rock mass but lead to the redistribution of initial stress, resulting in rock mass in a new stress environment. The static stress in rock mass has the characteristics of dynamic change. For the purpose of investigating the effect of increasing static stress on attenuation mechanism and energy dissipation of stress wave in sandstone under the overall deformation condition, small disturbance experiments on sandstone bar are carried out with a modified split-Hopkinson pressure bar test system. The stress waveform, p wave velocity, temporal and spatial attenuation of amplitude, and energy dissipation are studied under various static stresses. Results show that stress waveforms at different locations are approximately the same, those at the same locations vary greatly, and the tensile waves that appeared at the tails of stress waves are larger with increasing static stress. With increasing static stress, p wave velocity experiences a dramatic increase, then develops gently, and finally a sharp decrease; the stress demarcation points are σs/σc = 30% and σs/σc = 55%, respectively. P wave velocity can be predicted by a quadratic equation when σs/σc > 63.69%. The relation between longitudinal wave velocity and static stress can be described by a quadratic function. Stress wave amplitudes decrease exponentially with increasing distance and time. Values of temporal spatial response intensity (RI) and spatial RI are approximately equal and present the same development tendency of nonlinear and linear stages due to the same dimensions. Values of temporal attenuation characteristic (AC) and spatial AC are differed by 2 or 3 orders of magnitude although they present the same development tendencies. Ratios of RI and AC can indicate the sensitivity of temporal and spatial attenuation to different static stresses. Full-wave energy declines in an exponential function with increasing static stress and decays as a logarithmic function with increasing distance. Widespread attenuation characteristics like these should provide a theoretical basis for rock mass stability analysis.

DYNAMIC RESPONSE OF MARBLE AND SANDSTONE UNDER ROTATIONAL STRESS

Micro-mechanical analysis of the effects of stress cycles on the dynamic and static mechanical properties of sandstone

Experimental study on stress wave attenuation and energy dissipation of sandstone under full deformation condition

Damage of Sandstone Induced by Repetitive Impact Loading

Experimental Research On Behaviors Of Saturated Loose Sand Subjected To Oblique Ellipse Stress Path

Mechanical Responses of a Porous Red Sandstone to Quasi-Static Cyclic Loads Under Uniaxial Compression

Nonlinear Mechanical and 3D Rupture Morphology of Saturated Porous Sandstone Under True Triaxial Stress

Dynamic Response and Damage Regularity of Sandstone with Different Moisture States under Cyclic Loading

The Influence of the Strain Rate and Prestatic Stress on the Dynamic Mechanical Properties of Sandstone—A Case Study from China

Study on Shear Slip Characteristics of Sandstone Plane Joints under Normal Dynamic Load Disturbance

Combined effect mechanism of linear loading and disturbance with different amplitudes on sandstone

Experimental study on the anisotropy of the effective stress coefficient of sandstone under true triaxial stress

Stress wave propagation and dynamic behavior of red sandstone with single bonded planar joint at various angles

Study on Dynamic Response of Rock Based on Split Hopkinson Pressure Bar Test

Characterization of the mechanical behavior and constitutive modeling of sandstone under acidic dry-wet cycles and dynamic loading

EXPERIMENTAL INVESTIGATION ON POROELASTICITY OF SANDSTONES

ELASTIC AND ATTENUATIVE ANISOTROPY OF BEDDING ROCK UNDER CYCLIC LOADING

Deformation and hysteresis behaviors of sandstone exposed to distinct sequences of variable-frequency compressive cyclic stresses

3D digital-image correlation insight into generalized relaxation behavior of sandstone under stress and pore pressure coupling

Theoretical Analysis of Longitudinal Wave Attenuation in a Stressed Rock With Variable Cross-Section

Effect of stress amplitude on mechanical and acoustic emission of sandstone under constant–cyclic loading