Abstract:Silicon-based materials are considered to be potential anode materials for Li-ion batteries due to their high electrochemical capacity, but their high volume change during charging and discharging, bad cycle life and low first Coulombic efficiency are the major problems that prevent their commercialization. Carbon materials have excellent electrical properties and can be used to cushion the expansion of silicon volume while simultaneously strengthening the electrical conductivity of the cathode material, which can secure a very high specific capacity while also increasing its cycling stability. In this study, a lignin-based phenolic resin (deep eutectic solvent-treated alkaline lignin) was used as the carbon source and Si nano-powder as the silicon source. The lignin-based phenolic resin was coated on the surface of silicon nanoparticles, and the carbon layer was obtained by carbonizing the outer layer of the resin through high-temperature calcination. The morphological composition of carbon and silicon was tested using scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffraction (XRD), thermogravimetric analysis (TGA), X-ray photoelectron spectroscopy (XPS) and Raman spectroscopy, and the carbon layer was found to be uniformly coated on the surface of the silicon nanoparticles. The electrochemical properties of the samples were also tested. Compared with pure phenolic resin-coated silicon, the cycling performance of lignin-based phenolic resin-coated silicon nanoparticles was significantly improved, with the best electrochemical performance of Si/C-LPR with an initial specific capacity of 782.45 mA h g −1 and a specific capacity of 605.43 mA h g −1 after 100 cycles (0.5 A g −1 ).

Study on Graphite Modified by Phenol Resin as Anode for Lithium Ion Battery

Modified Graphite As Anode for Lithium Ion Battery

INVESTIGATION OF GRAPHITE COATED WITH PHENOL RESIN AS ANODE FOR LITHIUM ION BATTERY

Study on Carbon Nanoparticles for Anode Materials of Lithium-Ion Battery

Research of Modified Graphite as Anode for Lithium Ion Battery

Pyrolytic Carbon Coated Graphite Anode for Lithium Ion Battery

Cabon Coated Natural Graphite As Anode Materials For Lithium-Ion Batteries

Phenol-Formaldehyde Resin Coated Graphited Needle Coke As Cathode for Lithium Ion Batteries

Modified Natural Flake Graphite with High Cycle Performance As Anode Material in Lithium Ion Batteries

Purification and Carbon-Film-Coating of Natural Graphite As Anode Materials for Li-Ion Batteries

Optimizing Pyrolysis of Resin Carbon for Anode of Lithium Ion Batteries

Modification mechanism of graphite anode in lithium-ion battery coated with ethylene tar pitch

Modification of Natural Graphite for Lithium Ion Batteries

Surface modification of graphite anode in lithium ion battery

Investigations on the modified natural graphite as anode materials in lithium ion battery

Effect of Carbon Coating on Electrochemical Performance of Treated Natural Graphite as Lithium-Ion Battery Anode Material

The shape modification of nature graphite powder used in lithium ion batteries

Preparation of Anode Material for Lithium Ion Battery by Chemical Oxidation

Li4ti5o12-Coated Graphite Anode Materials for Lithium-Ion Batteries

Surface Modifications of Carbon Materials Used As Anode of Lithium Ion BatteryⅡ.The Carbon Material with Core Shell Structure and Its Positive Effect on Cell Performance of Graphite Anode

Pomegranate like silicon–carbon composites prepared from lignin-derived phenolic resins as anode materials for lithium-ion batteries