Abstract:Charge accumulation usually happens on the surface of spacers under DC operation, which is susceptible to inducing surface flashover. In order to explore the surface charge accumulation mechanisms and the influences of dielectric conductivity, gas ion mobility, and temperature field on the surface charges, a time-varying charge density model at the gas–solid interface of spacers was established. The results of the simulation show that the discontinuity of the current density between the spacer bulk side and the gas ion flow is the fundamental reason for the charge accumulation on the spacer surface. Additionally, the value of current density fluxes at the interface continues to decrease with the change of the electric field, and the progress of charge transfer gradually stabilizes. Moreover, the dielectric conductivity directly affects the charge accumulation process, and there is a critical conductivity in which the effect of charge conduction in dielectrics counteracts that of gas-phase charge deposition, theoretically. When the conductivity is higher than the critical conductivity, the solid-side charge conduction is the main source of the surface charge accumulation, while the gas-phase charge deposition on the gas side plays a dominant role when the conductivity is lower than the critical conductivity. The charge accumulation is not significantly affected by gas ion mobility when the temperature is evenly distributed. However, under the temperature field with gradient distribution, the current density fluxes at the interface change, causing the polarity reverse of the accumulated charge. In the high-temperature region, the volume current density surges simultaneously with the conductivity, leading to a higher density of surface charge accumulation. Lastly, the design of spacers needs to keep the current densities on both sides of the interface as similar as possible in order to avoid excessive charge gathering in localized areas.

Analysis of Charge Accumulation at Dielectric Interface

A simple method considering the synergetic effect of space charge and inhomogeneous material conductivity for DC electric field computation

Modeling of a charged dielectric interface: Comparison of the continuum and discrete lattice representations of surface charges

Charge Behaviors At Surface And Interface Under Ac Electric Field

Inversion Algorithm to Calculate Charge Density on Solid Dielectric Surface Based on Surface Potential Measurement

Surface Charge Density in Electrical Double Layer Capacitors with Nanoscale Cathode–Anode Separation

FEM Simulation of Charge Accumulation Behaviours on Polyimide Surface in 10 kV Negative High-Voltage Corona Polarization Process

Ionic Charge Accumulation at Microscopic Interfaces in Filled Composites

Charge accumulation and potential difference generation in ion adsorbing cells

Measurement Method and Accumulation Characteristics of Surface Charge Distribution on Polymeric Material under DC Voltage

Surface Charge Accumulation Phenomenon at the Gas-solid Interface Under DC Voltage

Calculation of Accumulated Charge on Surface of Insulated House Near DC Transmission Lines by Method of Characteristics

Investigation of surface charge density on solid–liquid interfaces by modulating the electrical double layer

Charge Density Evolution Governing Interfacial Friction

Surface Charge Accumulation Behavior on Al2O3-filled Epoxy Composites with Rough Surface under DC Voltages

Characteristics of Surface Charge Accumulation on Spacers and Its Influencing Factors

Effect of insulation distance on surface charge accumulation at the gas-solid interface under DC voltage

The Evolution Characteristics of Surface Charge on the Gas–solid Interface under the Long-Time Co-Action of DC-temperature Gradient

Simulation on the Influence of Bipolar Charge Injection and Trapping on Surface Potential Decay of Polyethylene

Numerical Analysis of the Discharge Characteristics of the Surface Charge AC-PDP

An Analytical Adhesion Model for Elastic Contact Electrification