Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Water Heat Transfer Characteristics of Internally Ribbed Tube in the Near Critical Pressure Region

Design and Optimization of Air Pre-Heater with Internally Ribbed Tube

Numerical analysis of buoyancy effect and heat transfer enhancement in flow of supercritical water through internally ribbed tubes

Comparison Between Heat Transfer to Supercritical Water in A Smooth Tube and in an Internally Ribbed Tube

Numerical study of supercritical-pressure fluid flows and heat transfer of methane in ribbed cooling tubes

Numerical Simulation of Heat Transfer in Finned Tube of Heat Recovery Unit Using Fluid-Solid Coupled Method

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Heat Transfer of R134a in a Horizontal Internally Ribbed Tube and in a Smooth Tube under Super Critical Pressure

Effect of Internal Helical-Rib Roughness on Mixed Convection Flow and Heat Transfer in Heated Horizontal Pipe Flow of Supercritical Water

Effects of Rib Geometries and Property Variations on Heat Transfer to Supercritical Water in Internally Ribbed Tubes

An experimental study on critical heat flux for low flow and low pressure of water in a hexagonal 7-rod bundle channel

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Heat Transfer Study of a Hybrid Smooth and Spirally Corrugated Tube

Numerical–Theoretical Analysis of Heat Transfer, Pressure Drop, and Fouling in Internal Helically Ribbed Tubes of Different Geometries

Turbulent flow and heat transfer in discrete double inclined ribs tube

Analysis of Local Heat Transfer Characteristics of Water and Steam in Helically-Coiled Tube

Numerical Study of Flow and Heat Transfer of Supercritical Water in Rifled Tubes Heated by One Side

Experimental study on single-phase heat transfer performance of internal helically finned tubes covering low Reynolds number in turbulent flow

Numerical Simulation of Heat Transfer and Pressure Drop Characteristics of Internal Microfin Tubes

Numerical study on heat transfer characteris tics of supercritical water in straight and helical tubes

Analysis of supercritical heat transfer in horizontal helical tube with internal roughness